USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
More than just a fancy name. TURNIGY nano-tech lithium polymer batteries are built with an LiCo nano-technology substrate complex greatly improving power transfer making the oxidation/reduction reaction more efficient, this helps electrons pass more freely from anode to cathode with less internal impedance. In short; less voltage sag and a higher discharge rate than a similar density lithium polymer (non nano-tech) battery. For those that love graphs, it means a straighter, longer curve. For pilots it spells stronger throttle punches and unreal straight-up performance. Excellent news for 3D pilots!
Unfortunately with other big brands; numbers, ratings and graphs can be fudged. Rest assured, TURNIGY nano-techs are the real deal, delivering unparalleled performance!
* The nano-core technology in lithium ion batteries is the application of nanometer conductive additives. 1) The nanometer conductive additives form ultrastrong electron-conducting networks in the electrodes which can increase electronic conductivity. 2) These additives create a superstrong ability for imbibition in the carrier liquid to supply more ion channels. This improves the ability of ion transmission and ion diffusion. Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly. Advantages over traditional Lipo batteries; -Power density reaches 7.5 kw/kg. -Less Voltage sag during high rate discharge, giving more power under load. -Internal impedance can reach as low as 1.2mΩ compared to that of 3mΩ of a standard Lipoly. -Greater thermal control, pack usually doesnt exceed 60degC -Thickness swelling during heavy load doesnt exceed 5%, compared to 15% of a normal Lipoly during heavy load. -Higher capacity during heavy discharge. More than 90% at 100% C rate. -Fast charge capable, up to 15C on some batteries. -Longer Cycle Life, almost double that of standard lipoly technology.
Hi saba I have this charger and it works fine with my 350mah 3s. PRODUCT ID: TGY-3
Though keep in mind that if you want to go higher or lower than 2s or 3s you will have to buy another charger. Hope this helps.
The sticker on the back says: Max Charge Rate:5C. This means that you can set charge current as follows: 5 x 0,370 A = 1,85 A at a max. I advise you to set a lower current and thus save cell life!
After using these batteries for a while I have decided from reading here and talking to others that it is best to do a balance charge at about 3C. So I do it at 1.2A. Great batteries!
You get more a longer flight and more punch if you charge at a 1C rate.At 5C they'll peak too fast and it's hard on any Li-Po. At a 1.5C rate they'll charge in 20 minutes. Just charge 6 packs at once in parallel,add up the total ma of Li-Po and start charging.You don't have to balance but once every 6-10 cycles.
Technically you're allowed to charge it at 1.85 amps, at a 5c rate (which is what most of these nanotechs have... so anything below that is up to you... i charge all my nanotechs at 5c and never have an issue... i have had the tabs break on a couple packs, but that's not related to the charge rate.
I just found some new info, this wire is rated 200*c... 20 awg needs 17a to heat to that temperature... so i think there will be zero issue with wire size here.
Customer Reviews
Overall Rating
spellcross
13 likes
Value
UNRATED
Quality
UNRATED
5 thumbs up!
I bought two packs. I have Recharger accucel6. The came exactly the same voltage each cell. First I charged (as they came) 180mAh. It gives enough power to my axi2204 with gws 8x4. I discharged one pack in the plane to 3,5V (per cell) and charged 354mAh after first flight with current 0,8A. It was done in 30 minutes, no puffing, no becoming hot. The second pack was discharged to 3,35V and charged 368mAh with 0,8A current. Seems pretty good!
3 comments. Reply..
Overall Rating
Trance183
755 likes
Value
UNRATED
Quality
UNRATED
2 thumbs up!
Bought one to desolder into single cells. Arrived with all cells at 3.81v and pack weighed 35.2g. Disassembled pack entirely and got 3 cells each weighing exactly 9.6g. Cells are very thin but wide.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
.jpg){kind=small}
