USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
J3 Blue Airplane Model w/ Brushless system Plug-n-Fly
Simple to fly, and only 20 minutes to build. All electronics are pre-installed and the included 2410/20A power system gives long flight times and plenty of power on as little as a 1000mAh 3S battery.
you can if you want to. It all depends on how much you want to fly it that way. If you do dont forget to get a y-harness. Hope this helps and happy flying.
hello i am a newby to electric flight and wanted to know if any one could tell me if my futaba trans. and rec. would work with this plane and what else i would need to start out
Your tx and rx will work just fine. The only other thing that you need is a 1000mah 3s lipo and if you don't have it a charger that is compatible with a 3s. Hope this helps and happy flying
I have this airplane, Good for beginners, highly recommend it. slow fly & park flying, it will float with no engine power (dead stick).it's like having aileron's with it. if you used 1000mah lipo bat you need to trim or cut a little bit the battery compartment, and it will caused no problem.
What kind of battery i need to use in 3 Blue Airplane Model w/ Brusshless system Plug-n-Fly ?
it required: 11.1V 1000mah 3S Lipoly but Battery compartment size is 50x50x41mm
If you used 1000mah, you must check the size and dimensions of your battery, mine was also 1000mah 3s. and it fly better, but I need to trim or cut the battery compartment to fit the 1000mah lipo bat. this unti feel like the airplane has a aileron
Hi there, I use the zippy compact 3s 25c. search ZC.1000.3S.25. I just cut out the front of the battery compartment so that it slides in snug. Flies great. My friend uses a turnigy nanotech 1000mah 2s, also flies great, but with less top speed/acceleration. Hope this helps, cheers
Hi guys, my accelerator are inverted. I use a Futaba 6j and the motor beeps a lot. I tried to find the ESC Guan'li programmer table, but I couln'd.
Does anyone help me?
Thanks!
****
Oi gente, meu acelerador esta invertido, segui vá*rias dicas mas nada. O ESC nã*o aceita as dicas que vi até* agora.
Algué*m tem uma idé*ia?
Valeu!
you wil haft to buy somethinf like female deans ot t connector to connect ro the battery or just suwich them out with jst wich is what i did and used a 3 cell 800 mad battery.
Yes it should. Only worry would be the weight. Don't know about HK's motor, but the one a pal has was from NP had good power but only gripe was it brought a lil tail heavy.
the box size is 35.5 inces/90 cm x 10inces/25.5cm x 4.25inces/11cm and you can fly it with 2s or 3s. I have floun it with 3s 1300 mha, i cut an space in the battery compartment in such a way that the battery stay vertical. you can use up to 1500mha.
at the very moment that you connect the battery move your radio throttle stick to the upper end and then go back. most of the Esc know the total traveller of your radio in that way.
could i run a 2200mah battery in this plane? I have other planes and buying this for a friend i have spare 2200mah so wondering if they would be ok or burn something out. Cheers
if you are a beginer DONT do it because during landing the plane will come down hard and it will prolly break the landing gears or the propeller. Keep it as much light as possible and then experiment
I see to put the prop on the hex with the size pointing forward , but does a flat washer go on next? How to tighten it without the inner hex nut loosening? The outer hex in the prop isn't used is it?
I know is silly question , but is my first assembly. Thanks.
use an electronic pliers to hold the rotor (motor), so you can tighten it. or there is an allen screw that tight the shaft to the rotor, use the allen key to hold the rotor in place.
Hi there it is a 3 channel, there are no ailerons or servo's for them but the marks are there as you say so it wouldnt be hard to fit some. I had this plane but binned it as it was underpowered on 2s 1000mah and came crashing down which snapped it in two due to the hard foam they have used.
no needs for 4channel, unless you want to roll this unit.It has a dihedral, I fly this unti also. and when it's up in the air you would not know the difference , unless you roll it.
i dont know exactly what they do in flight, but the elevator is mainly for going up and down, and ailerons help with turning, and the rudder helps with turning as well. (someone please correct me if im wrong)
Please could you give me the size of the propeller of the plane :J3 Blue Airplane Model w/ Brusshless system Plug-n-Fly. PRODUCT ID: HK-J3B. Because I would like to order another propeller too. Thank you.
chargers for batteries ? HobbyKing E4 Balance Charger - I use this. It requires 12V input power supply :) This product includes charger & balancer, so is perfect for you and pretty cheap!
personally i love my Aurora 9 regarding Tx's.
For recharger i like a lot the ACUCELL 6 by Turnigy because it comes with croco tips and i can use it on car's battery. With a couple of 1300mah i can fly restless.
any 11.1V 3S or 7.4V 2S will fit into this compartment because even on the HK site is written that the compartment size is 50x50x41mm, I have spoken with lot of people and the battery will fix. I've had the same issue, but I've got it! enjoy.
You should be able to use a slightly larger battery (power wise) and 25c or 30c is only the discharge rate, how much power can be given out at any one time. Depends on the speed controller and motor to how many mah (milliamp hours) you can put into the plane. If you used a smaller battery, you may have issues taking off, but other people have said it can go real slow.
ofc you can use a razor to dig your way in the fuselage and make enough space for your batteries. Just care the CoG and the servo movement.
Customer Reviews
Overall Rating
rcgromov
105 likes
Value
UNRATED
Quality
UNRATED
Like it?
This is an email to inform you that we have received your order and it has been sent to the warehouse print queue for dispatch.
No comments. Reply..
Overall Rating
kekelala
301 likes
Value
UNRATED
Quality
UNRATED
Like it?
Nice finish for its price and the plane took off in about 10 meters with a 2S 20C lipo at 75 throttle. Wow... Slow, nice, steady. Will standby a kit for it if I crash it. Hehee!
Landing gear is sturdy for its weight though it looks weak.
Cons: If only the brushless motor doesn't come with the screw-type shaft, I could have several other props and collets to play with.
Nice plane. Came in thermocol mold. The texture of the plane is like balsa. I could not make out the material without touching it. Amazing price. The propellers provided are not of good quality so I recommend that you upgrade the propeller. The ESC gets hot so if you can upgrade the ESC to a higher rating, please do so. The plane flew well and was stable.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
.jpg){kind=small}
.jpg){kind=small}
.jpg){kind=small}
