USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Hi, This carb is suitable for SPE 26 and side carb engines, previous generation. If you have a engine around 20-30 cc, this carb is ideal. Note:This carb does not have the provision to connect engine vaccum from crank case to carb diaphram. WIll fit RCGF 15, 20, 26 cc engines.
I would like to use this carb on a modified 4 stroke. Could I connect the vacuum bulb pipe to a nipple on the crank case breather to activate the pump?
This second inlet line would normally be used if the carb had a primer bulb on it.It is normally where the return line would be connected back to the tank.When you pump the primer bulb,it sucks gas from the tank into the carburetor and eventually removes any air that is in the carb.You will see air bubbles exiting the carbs return line and returning back to the fuel tank.Normally after 5 presses of the primer bulb,it has removed any air that was trapped in the carb allowing for easier and quicker starts.
Sincethis carb has no primer bulb feature,the return line must remain capped somehow to prevent possible vacuum leaks.Soldering over the 1/8" brass tube is also another option if you don't want to have to look at that ugly green piece of fuel line with the plug in the end of it.
Hi TM KITS, I have used this carb for 15-25 cc gas engines, SPE, RCGF, JBA kind of engines. Only draw back is no provision for vacuum from crank case to diaphram found in other 50cc engines. Suction is less, and take time during first start, else a good buy.
only 3 start because seller must put more information about this products!!. The item deserve 5 start really.
Good carburettor for 20-23 cc engine but I think that it is a bit small for 26 to 30 cc if you want more extra racing power. I will try this carburettor in a marine 26cc Zenoah and I will put a review here.
No comments. Reply..
Overall Rating
guyinthesky
18 likes
Value
UNRATED
Quality
UNRATED
2 thumbs up!
This carb attached to my FTL 26cc engine is marked WT-824 973A. I cannot find any reference to this number on the Walbro website (www.walbro.com). It is said that the Walbro kit number for all WT carbs is K20-WAT (according to dwebz.net/Misc_webs/WALBROpcnt20CARBURETORS.htm). I can't confirm that this is true.
Great value on this carb, made my engine, run twice as good as the orginal.. thanks.
No comments. Reply..
Overall Rating
TMKits
19 likes
Value
UNRATED
Quality
UNRATED
1 thumbs up!
What walbro part number is this? Looks like a WT XXX?
No comments. Reply..
Overall Rating
gerryman
11499 likes
Value
UNRATED
Quality
UNRATED
1 thumbs up!
Yo uso carburadores Walbro desde hace mas de 15 años, y considero que son optimos, los tengo en motores Zenoah 23, 45 y 62 cm, vienen de fabrica, nunca me han fallado, solo hay que tener en cuenta vaciar la nafta de su interior si va a quedar fuera de uso el motor por mucho tiempo
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
