Turnigy Marine 80A-HV

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

Does anyone know what the extra wires are for on this esc? It has two sets of radio wires and a small thin black(negative) wire that has a fuse or something shrink wraped on it.
The manual says nothing about any of these wires. I dont want to hook up anything til I find out....real nice instructions!  
Jeff

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
Bluduc Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (US) USERID: 22520 Newbie Joined: 17/May/2009 Online Status: Offline Posts: 1	Quote Reply Topic: Turnigy Marine 80A-HV Posted: 27/May/2009 at 11:34am
	Does anyone know what the extra wires are for on this esc? It has two sets of radio wires and a small thin black(negative) wire that has a fuse or something shrink wraped on it. The manual says nothing about any of these wires. I dont want to hook up anything til I find out....real nice instructions! Jeff

Mustang Sally Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (AE) USERID: 52654 Hobbyking Addict Joined: 19/Feb/2009 Online Status: Offline Posts: 1956	Quote Reply Posted: 30/May/2009 at 7:45am
	Are the radio wires the same lenght? One is for the RX and the other one to connect to the Program card when you prgram it. Like this you don't have to disconnect from the RX when you program the ESC. The thin black wire, I am not sure of, could be the Hal sensor wire for sensored motors? Edited by Mustang Sally - 30/May/2009 at 7:46am

karolpenconek Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (PL) USERID: 134710 Newbie Joined: 31/May/2009 Online Status: Offline Posts: 1	Quote Reply Posted: 31/May/2009 at 3:06pm
	Hello. It have one extra radio wire, mabye for programming card. This small black cable you can cut (propably it's a resistor for provisoric BEC????) and esc runs good without it. Karol, Poland

customer Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (DK) USERID: 33724 Newbie Joined: 10/Mar/2009 Online Status: Offline Posts: 6	Quote Reply Posted: 05/Apr/2011 at 10:28pm
	The small black wire with the "fuse" is used to ellminate giant spark when connecting lipo. saves the electronics, and the power plugs. You should solder half of the wire to lipos negative wire (black one) with a small 1-2mm bullit plug. First you connect the + batt to esc, and then connect the little black wire with the fuse between esc negative - and lipo negative - wait for 2-3sek and then connect lipo negative power plug to esc negative power plug, and then you can unplug the little black wire. (make sure that you dont short circuit anything, so put a isolated plug on each ends)