Replace swash with Align?

Is it possible to replace my HK600's swash plate with the unit from Align? I purchased a couple of Align Main Shaft Bearings but they appear to be wider than the HK versions and won't fit between the body halves. So, I'm wondering if the balls on the Align Swash won't be too far apart also.

Thanks in advance everyone.

I discovered my problem. I purchased the wrong damn parts!!
The Align bearing blocks I bought are intended for the nitro version not electric, and are therefore wider than needed. Anybody need a new set of N bearing blocks ?

Thanks Kev.

I've solved that problem with a pair of the correct bearing blocks, now I'm off on another problem.

I've installed an Align DFC Flybarless head on my HK600 and it looks spectacular. Unfortunately, the HK anti-rotation bracket is a tiny bit too tall. When I spin the head with my fingers, the head just barely touches the anti-rotation bracket when it passes. Looks like I'll have to find a replacement, or shorten the HK version.

Any ideas ?

Thanks in advance
Mark

Thanks again Kev;

I solved the whole problem by drilling two new holes in the CF upright portion of the anti-rotation bracket thereby lowering it by 1/8 inch. This was enough to permit free rotation of my new Align DFC setup with the new shortened shaft.

Thanks again
DillsburgMark