Trackstar help???

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

Hi guys

       Just wondering whats the best way to connect motor wires to a Turnigy trackstar motor. It has three rings for wires and i was going to simply solder the wires but if someone has a better way then please im all ears!!!

Im new to brushless motors and any advice would be greatly appreciated

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
blitzbasha Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (AU) USERID: 1530774 Newbie Joined: 13/Jun/2012 Online Status: Offline Posts: 3	Quote Reply Topic: Trackstar help??? Posted: 21/Jun/2012 at 5:27am
	Hi guys Just wondering whats the best way to connect motor wires to a Turnigy trackstar motor. It has three rings for wires and i was going to simply solder the wires but if someone has a better way then please im all ears!!! Im new to brushless motors and any advice would be greatly appreciated

Daithi Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (GB) USERID: 1241240 Hobbyking Addict Joined: 06/Jan/2012 Location: Belfast,Ireland Online Status: Offline Posts: 2587	Quote Reply Posted: 21/Jun/2012 at 6:13am
	Soldering would be best (and heatshrink tubing over the joints). Slip a length of heatshrink on first, slide it to the end (away from the joint), solder, bring up the tubing (after you check the motor is running the right way round of course) and then shrink into place
	I don't care what it says on the profile - I'm so NOT GB!