Adding an OSD to Fatshark / ImmersionRC VTX tip..

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

Hey guys, just thought I would share a little tip that I discovered....

I have Predators with the 100mw rx and also have the Imersionrc 600mw rx but I needed to connect my GOSD (running CL-OSD firmware) to video feed on the vrx but as you know the wires going to the fatshark camera a very thin.

So I got one of these

And it just fit's in nicely on the back of the vtx where the little pins are. I have just run the video & ground (snipped off the wire that connected to the 5v output) and then just put a plug on the end and hey presto it connects to my OSD without the need to cut into the fatshark wires!

Edited by Damage2008 - 04/Aug/2012 at 9:40pm

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
Damage2008 Members Profile Send Private Message Find Members Posts Add to Buddy List Platinum (GB) USERID: 459626 HobbyKing Constituent Joined: 06/Jan/2011 Online Status: Offline Posts: 160	Quote Reply Topic: Adding an OSD to Fatshark / ImmersionRC VTX tip.. Posted: 04/Aug/2012 at 9:39pm
	Hey guys, just thought I would share a little tip that I discovered.... I have Predators with the 100mw rx and also have the Imersionrc 600mw rx but I needed to connect my GOSD (running CL-OSD firmware) to video feed on the vrx but as you know the wires going to the fatshark camera a very thin. So I got one of these And it just fit's in nicely on the back of the vtx where the little pins are. I have just run the video & ground (snipped off the wire that connected to the 5v output) and then just put a plug on the end and hey presto it connects to my OSD without the need to cut into the fatshark wires! Edited by Damage2008 - 04/Aug/2012 at 9:40pm