Planes & Parts
Helicopters & Parts
Multi-Rotors & Parts
Cars & Parts
Boats & Parts
Bikes & Parts
Scale R/C Tanks
FPV & Telemetry
Batteries & Accessories
Chargers & Accessories
Robotics & DIY
Servos & Parts
Radios & Receivers
Gas/Glow Engines & parts
UBEC & Regulator
Hardware & accessories.
Clothing, Gift & Acc.
USA warehouse now open. Our USA warehouse is now open!
Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
All GWS EP Propellers Stocked! GWS EP Propeller (DD-4540 114x102mm) Colours vary. Not always orange
DD:Direct Drive (fast spinning) -Straight Edge RD:Reduction Drive (Slow Fly, Outrunner or Gearbox) - Curved Edge
Note: Propeller's colour may differ from that in the photo
PRODUCT ID: GWS-prop-DD-4540
Length (Inch [X])
Pitch (Inch [Y])
Update/Add my own data
Where is the stock. Come on HK.
do these props work with the Micro 182 Light Aircraft 550mm
100 points - 4/5/2012
will this can be used on any speed motor?
yes this prop is basically for speedy motors you can use any high kv motor!
BEST ANSWER CREDIT AWARDED
Yes, I point out to you a 3700kv motor and near 40 amps, has a very cheap at: www.link the site of one's own hobbyling with this engine and propeller, you can reach 1300g of thrust and a speed of up to 120 miles / h or 267 km / h. good purchases.
Whatever happened to the 4530 prop you used to stock? Are these 4540's better? Looking at the pitch, it seems quite 'square'. Anyone can comment on your experience with these? Thanks. Pete
What is the hole size for this one?
Should be the usual 3mm shaft hole diameter.
It's 4mm shaft. You'll need to get a prop saver with the 4mm shaft for your 3mm motor.