Planes & Parts
Helicopters & Parts
Multi-Rotors & Parts
Cars & Parts
Boats & Parts
Bikes & Parts
Scale R/C Tanks
FPV & Telemetry
Batteries & Accessories
Chargers & Accessories
Robotics & DIY
Servos & Parts
Radios & Receivers
Gas/Glow Engines & parts
UBEC & Regulator
Hardware & accessories.
Clothing, Gift & Acc.
USA warehouse now open. Our USA warehouse is now open!
Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
All GWS EP Propellers Stocked! GWS EP Propeller (DD-7035 178x89mm) Colours vary. Not always orange
DD:Direct Drive (fast spinning) -Straight Edge RD:Reduction Drive (Slow Fly, Outrunner or Gearbox) - Curved Edge
Note: Propeller's colour may differ from that in the photo
PRODUCT ID: GWS-prop-DD-7035
Length (Inch [X])
Pitch (Inch [Y])
Update/Add my own data
will this prop work on the EDGE 540QQ ?
From all the reading that I have done on prop alternatives for the edge 540qq, the GWS 7035 does fit but you do have to reverse the nut on the motor shaft.
What diameter of hole ?
Please credit if it helps.
3mm not more not less :)
Is it possible to use it Counterclockwise or Clockwise?
Usually a prop rotates CW from the pilots point of view. The numbers always face to the direction of travel, normally facing front, away from the motor.
If you are using a pusher configuration the prop is mounted so the numbers face the motor. It still rotates CW when viewed from behind.
The motor itself rotates the opposite direction on a pusher configuration than conventional. Props work the same ether way.
BEST ANSWER CREDIT AWARDED
would this be a good prop for the HK mini P51 mustang park flyer?
It may work but maybe a bit small.
Look for an Art-Tech 8407 8.5×6 Propeller.
it depend of your motor...
How big is the hole?
Will it fit on 3.17mm threaded shaft like on the
"Turnigy 28-22-azj 7A 1400Kv"?
I think it will fit
You can allways make it fit with a drill.
If it's too small, it's very easy to ream (even by using a mini screwdriver :)