Nylon Stopper 12x4x1.5mm (10pcs/set)

 k.smith459 52 points

.062 music wire is 1.57mm

 crashnfoam 29 points

.062 music wire is 1.57mm and would be a better fit.

 handyjap 195 points

Try the Nylon Snap-Click style clevis 10pc PRODUCT ID: OR012-00702, they are for 1mm wire which still not ideal but closer to 0.032"/0.8128mm. It might work if you can bend the catch/fold around the wire a bit more close (worked for me on a 775mm foamy Cessna with thinner replacement wired without thread).

 Tucknut 10 points

I just received a pack of these and I agree with the reviewer about the .8mm hole. These are basically identical to Dubro part #849 which are designed for .032 wire.

 Porter 20 4 points

Yes these are suitable for 0.032" wire .They would not suit 1.5mm wire.

 kanara27 16 points

Must use 1.5mm rod. It is conection between rod and arm of servo. Bend the rode 90 degree and click it.

 Tsvetan 8 points

This is a very good clip for fixing the 1.5 mm rod. It is used not only for fixing the rod from the servo but on both sides. Cut the required length of rod small stock length. Fold pipe in the direction to enter the hole in the servo 90 degrees (or horn valve) insert in the hole then insert the servo hole Nylon Stopper and then into the groove along the bar. Good luck.

 CARSLOS ANDRE 58 points

Make a 90 degree bend in the rod tip then you pass the shaft or the servo horn eai puts Nylon Stopper

 TIGRE 61 points

It´s very useful asuring the rod with the arm of servo if vibrations.

 Cilene 4 points

muito bom, resistente, facil manejo, para eletrico é otimo

 hinam 13 points

All time i am use Nylon Stoper - it's o.k.

 Sudiptolal 6 points

Make a 90 degree bend at the end of the 1.5mm rod connecting to the horn, the bent end must extend out of the horn enough to fix into the nylone stopper hole and just peep out, now clip the 'U' cut part of the stopper on to the length of the rod, the horn is now locked.

 Nriquitor 8 points

Estupendos para asegurar las varillas

 vmail 8 points

It is ok for the rode of 1,5 mm.
Bend the rode 90 degree then insert the rode in the hole of the nylon stopper and click in the rode.

 jose luis 3 points

the rebar that goes to the horns when you pass by the horns Clevie you put the tip of which is 1.5 and the fat part of the return to put on the scroll bar on the line

 Uberfest 31 points

pra eletricos, use arames de aço

 leonardi 12 points

But how to mount it to the servo arm? Should I put a screw to the hole in this to secure it the the servo arm?

 TIGRE 61 points

Kanara27, in his above post, explain perfectly how to mount it.