Ordered that carbon prop several weeks ago, quality looked great and everything...
Everything looked good, by chance the prop is pre-drilled with a 10mm hole, that was matching perfectly my motor that also has a shaft of 10mm in diameter, but everything went real sour after I mounted the prop on the shaft, they didn't drill the hole at 90 degrees, but a few degrees off !!
This is real bad... and that prop, drilled like that, is useless.
I guess it could be butchered, but this is a real headache afterwards to align the 6 hex fasteners...
I am contacting tech support at HK...
2 comments. Reply..
Quality is 6 out of 10... not sure if this prop is glass covered wood or not but does not appear to be built like a CF Mejzlik. The finish on mine is horrible, with massive drips/drools of clear-coat... prop was way out of balance too... I used mine on a static display... not sure I would use on a real model spinning it 7k rpm and such... could get ugly quick.