USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
É* muito bom algué*m informar se essa mesa acompanha o braç*o de acionamento , pois nã*o consta na foto sendo assim fica complicado se comprar sem o acionador
what lenth control arms will fit these trays? Iv been waiting over a month for mine to show up to measure the distance, but if some one could tell me the lenths, I could just go and order them!
Customer Reviews
Overall Rating
Hady Esta
118 likes
Value
Quality
Like it?
this item is really good, the finishing is superb , it is solid as a rock ,
i bought this item to use it on a extra 300 40pcnt and its just what i needed . excellent product for the fraction of the price of SWB .
1 comment. Reply..
Overall Rating
justice
447 likes
Value
Quality
Like it?
brought this for a extra 330 35pcnt. great item and very solid,though its no good for me. the servo openings dont match where it needs to sit,alos the nuts on the bottem are in the way which meens that 4 extra holes will need to be drilled to allow the tray to sit flat. this is not a screw in and forget item. I need to do mods to the airframe to make it fit.I also cat get to the back of the tray to drill holes for fitment. for me,it was a waste of money!
No comments. Reply..
Overall Rating
justice
447 likes
Value
Quality
Like it?
continued... just put my hitec HS-7954SH's into the tray to see if the screw holes line up,they dont even come close. the screw holes in the tray are to far apart for these servo and you will not get bigger servo's to fit either. I recommend not buying. dont waste your money !!!
so why would you want this thing ? ANSWER: Just think how tight you must make the pull pull system on your plane so you don't have slop Ok now you are pulling the out put gear on your servo side ways and 2 gears that's not parallel tend to strip gears so this takes of the strain on you servo horn and gears and the servo can concentrate on doing its job which is just to move the control surface not to keep cables tight as well it is light has bearings and you need the Alloy Push / Pull Elevator/Rudder Bell-crank which is sold separately PRODUCT ID: RUD-B
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
