HK15148 Analog Servo 17g / 2.5kg / 0.14s

 Pushrod 585 points

You can use a z bend in the pushrod or you can buy Linkage Stoppers D2.1mm (10sets)
SKU: 016-00503x10

 NewToHobbyKing 6437 points

Buick that is it us a Z bend, a L bend and clip or my favorite a push bike spoke and a clevis. So many ways. So where is the servo going?

 NewToHobbyKing 6437 points

Gusfly but look at the price! How can you make a servo for that money??

 hpachon 1576 points

si claro estos servos te sirven perfectamente ni mas ni menos

 TeslaBEM 36 points

To control this you should send control pulse at least every 20mS, the de pulse must be from 0.5mS = 0°, 1.5mS = 90° and 2.5mS = 180°. It's easier with Arduino and the Arduino Servo Library, but it isn't that hard in PIC.

 pr0fab 441 points

Specyfikacja nie moż*e odbiegać* od rzeczywistoś*ci.

 jerry-tom 269 points

Yes, it works reliably.

 joseimpo 159 points

Puedes usarlos sin ningun problema, el cable naranja es el de señal, equivalente al blanco de furaba

 beyond limits 18 points

Yes they have a futaba compatible plug

 edwin jose 7 points

Yes, there are standar, the diference is that yelow wire is the white wire but it's the signal wire, you can used this, no problem

 Bajadude 842 points

Yes and they are really cheap :)

 christiano 76 points

no, find a std servo and be happy

 Olderflier72 5 points

it will be fine as a throle sev. if you need to save a little money. i even use the smaller HK15148. i can mount it up front and it saves a little space and weight.

allen

 __BB-Q 212 points

Be careful that you set the end travel correctly, as the motor is much more powerful than the gears and will strip them if it tries to travel too far. I start off with my servo movements at 50pcnt and gradually increase from there, watching the throttle arm movement.

 merlind 14 points

question

 christiano 76 points

yes you can use it

 Shura 122 points

Excellent product for excellent price. I am happy to use them

 Joseph 22 points

Not sure what the question is, but on this servo the brown wire is the ground and is equivalent to the black wire on futaba. The red is positive and is the same as the red on futaba and the orange wire is the signal wire and is the same as the white on futaba. In addition, I have only had the servo a short time but it's quiet with very little slop in the gears and appears to have very good torque for it's size. I plan to get more

 Shura 122 points

question or statement

 merlind 14 points

it has an advantage, you can differentiate it from afar by the color, the black boxes of commercial airplanes are orange to differentiate between the remains of a disaster

 PoulBorge 21 points

No problem. The picture shows a selection of output arms.

 sandyjain 33 points

I can see that the servo comes with arms - BUT I need to know if futaba arms will fit or not ? Futaba has 25 teeth, JR has 24 and Hitech has 23 - How many does Hobby King have ?

 Joseph 22 points

The standard Futaba servo arms will not fit. The output shaft diameter of this servo is smaller than a futaba servo. I don't have any JR servos, so I can't help you there.

 christiano 76 points

yes, you can use with futaba and JR