Replacement 2-Blade Propeller (8.5x9)

 Dongskie 228 points

This prop is too big for your micro 182. You need at least a 5X6 prop for your micro 182

 Dongskie 228 points

I actually used this prop on a 700mm SPAD and it flew way better..

 diy-pro 290 points

That prop is way too large! The stock is 5x5 if you ran on 2s 6x5 would be fine but 3s would mean a motor and esc upgrade as far as i can tell. Sorry for late reply :p

 Rudi 1 points

yes ..but its a bit small i guess

 Celine 5 points

yes it will fit very well

 ThiagoKern 11 points

yes you can use it

 eloyalbacete 15 points

I have this model and use this propeller separate replacement also bought the 8X 6 sf here

 stefano 14 points

x esperienza è meglio la 9x6 comunque la 8.5x9 c'è da hk

 -MLG- 387 points

The hole is 3mm. But you have to know how kv has your motor,.. The best prop for your cessna is the original you got it with plane. If you want a bit faster plane you can put 1 inch bigger prop or 1 inch longer step. But you have to test it before the flight,.. The motor or ESC must not get too hot!!!

 parkep 4 points

Yes. This is the correct prop. Also firs the Piper J3 Cub 960mm

 Will 1 points

I bought two of these for my bixler on your advice. They're massive. They don't fit at all.

 -MLG- 387 points

Nop shure it wont fit!! You can put 1 inch bigger then the original prop or 1 inch longer step, but not both at the same time!! Test it before flight, the motor or ESC must not get too hot

 -MLG- 387 points

Yes it will fit, but it will be slower.

 -MLG- 387 points

No I was wrong I think it will fit perfectly. If you have 1300kv motor (there is label on motor).

 frank 22 points

This is the prop for (FMS)mini warbird 8oo mm or 750 mm series.Werry rigid and can take hard beatings.Fitts p-47.p-51.Bf 109.spitfire etc.It has big pitch so it can run on 2 cell setup.