USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Zippy Flightmax batteries deliver full capacity & discharge as well as being the best value batteries in the hobby market today!
Hardcase packs are a must for RC Car enthusiasts. The case helps to ensure that the batteries can stand up to the added stress and shock associated with R/C vehicles.
Just curious how these weigh LESS than most "shrink wrapped" batteries of same mah and C rating? You'd think the plastic case would make them weigh more. I was looking for the lightest 5Ah battery for my small quad and this seems to be the lightest....is there anything other than "that's weird" about running a hard case battery made for a car, on an aircraft?
I noticed this hardcase pack is lighter too. I wonder if it is a typo. I have the 5000mah 20c and it weighs in right at 400 grams and also $10 bucks cheaper. Works great for my X900 tricopter and DJI quad.
Hello,
I would need to use this (ZIPPY Flightmax 5000mAh 3S1P 20C hardcase pack USA Warehouse)in a Traxxas Stampede and charge it with a Traxxas charger.
Does HK offer the 4mm male bullet-to-Traxxas power connector female adapter plug?
Also for LiPo balance the Traxxas LiPo charger has "standard XH balance connectors." Is this battery's balance connector compatible with Traxxas balance charger?
Thank you,
Mark
Little Rock, Arkansas
Will these fit in the battery trays of a Traxxas Summit or E-Revo without the need to moddify either? Also, if the battery is defective is return shipping by standard US mail to a USA address?
should fit in a slash no revo no problem. the hight may be a slight issue but the taller screws that have the body pin go threw. that traxxas sells can solve that
they are too tall for stock battery tray in slash you have to get the kit that raises the strap or put a longer screw in were the body clip goes and raise the back part also not to big of a deal , summit and revo might be to tall of battery
yes, I think so, but you may need to loosen the battery hold down screws to effectively raise the hold down due to the thickness/height of battery - very simple.
the 4x4 slash has a shorter battery tray than 2wd slash and this is a tall battery, it needs the kit to raise battery strap for either rc will not fit in stock form! battery is too tall beacause is a 3s traxxas makes a kit now for taller batterys not sure of part# thow
you have to buy the battery expansion kit which costs about $6-10
Customer Reviews
Overall Rating
9sec240
48 likes
Value
UNRATED
Quality
UNRATED
Like it?
These batteries fit the Traxxas Rustler / Bandit VXL chassis perfectly when you add the Traxxas 3725X Battery Expansion Kit. You will need to replace the connector on the battery or ESC to match or simply build an adapter that goes from 4 mm bullet to Traxxas as I did. I have clocked my Rustler VXL at 60 MPH on radar with 31 / 76 gearing and this battery. Wheelies are effortless at anything below 50 MPH. Run times are hard to gauge because the ESC goes into thermal shutdown after about 10 min of hard use. I would highly suggest the optional Traxxas fan kit for the ESC. These batteries are ridiculously inexpensive when compared to maxamps.
2 comments. Reply..
Overall Rating
Customer
26 likes
Value
UNRATED
Quality
UNRATED
Like it?
ordered two and both balanced,and yes fixs the rustler well,i would buy these again,I did change the plug to deans
No comments. Reply..
Overall Rating
Dulpyps
22 likes
Value
Quality
Like it?
Love this LIPO, my only gripe is that it's too long to fit into my HK-450 PRO V2. I'll be playing around with the postioning on battery tray to se if it will fit with body on. I'm thinkng of trying to mount it under heli, even though it seems a bit unconventional. I'll let You now how it works out
1 comment. Reply..
Overall Rating
5/6/2013 Reece
4 likes
Value
Quality
Like it?
All I can say is this battery is great! Fits my slash 4x4 after adding zap straps around the piece that holds the battery then putting them through the holes where the back of the tray holder fits into. Cheap way of allowing the battery to fit. My shafts in my slash have not twisted yet but the ESC/Motor gets hot. Will be ordering a 1/8th scale motor and ESC.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved