This Small and lightweight UBEC features a High efficiency switch mode design providing better heat dissipation when compared to the linear voltage regulators. The shielded PCB design and output EMF coil makes helps provide a stable and low noise voltage output. This UBEC also features built-in reverse polarity protection.
Specs: Input: 6V-23V (2-5S Lipoly, 2-6S Li-Fe or 5-15S NiXX Battery Pack) Output: 3.3V/3A (Less than 50mV peak to peak voltage @ 2A) Dimension: 22.9mm x 20.3mm x 7.6mm (LxWxH) Weight: 5g (w/o wires) or 7.1g (wires included)
Note: An instruction manual for this item is available from the files tab below.
This is probably a really retarded question but I have to figure this out. So if Im not going to have an extra channel for my BEC to plug in is it possible to run the wires together with my ESC and plug them into the same channel? Or is there other way I can hook this up to my 6 channel receiver on my 450?? If somebody knows how I can solve this problem will you please help me??