USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
On my Slash 4x4, I Got it installed on my Velineon 3500 directly plugged on the esc red female plug. Note the Fan came equiped with the Female plug also, so I had to replace by the Male one which is delivered together with it in the pack.
I have one on my rustler but I put a brushless system in as well. You could bend this heat sink to fit the 550 modified motor that comes stock just make sure to take off the metal band with the sticker on it. This heat sink will also work with the vxl motor.
Some times the fan becomes popped out of the motor and needs to be pushed back in, but when I received my motor it worked flawlessly but I've had a fan not work before with other fans
First, try turning it with your finger and if it does not turn of if it does not turn smoothly, check for blockages and dirt. If the fan turns smoothly there is probably a broken wire somewhere.
2 spitfireQuebec: it's for inrunner motor, not outrunner, :)
so the coils, that are around the stator, heat up and this helps cool them down.
in an outrunner, the coils are inside like you stated.
i wonder what is the running current of this fan, cause i think BECs are usually about 3A and the steering servo on a 1/10-1/8 car can take up to 2A i think so that leaves an amper for the fan and thats already kinda pushing the BEC
Normally it's a 6 volt Fan, because when your are using a Fan with an higher voltage it won't turn, because the normal voltage in an Rc car is 2S Lipo with 7,4 volt!!
yeah i have the same problem, need fan for beetle 1/16 motor. Or maybe just put a 36mm motor with this fan in it, 100A esc, 5000mah nanotech 3s lipo and see where this will take you ))))
I run 3S on the beetle and fitted two EFLM1912 E-Flite Heat Sink 20mm x 20mm. they were about 5 bucks each with heatsink compound. Mine doesn't overheat at all anymore. I also added 20 x 20 5V fan to the standard ESC as I was gettin thermal cutout after about 5 minutes of flat out running.
this done diddly squat zero to cool my traxxas velinion set up slash 4x4 platinum , i can fart harder than this fan but the heatsinks ok , thermal protection kicks in still around the same time and the fan does zero to cool the motor while sitting in shade waiting for motor to chill etc may as well blow on it , i was hoping to use a turnigy fan like on the larger heatsinks bought here there brilliant but the turnigy fan on this is to big unless you make some larger bars for attachment which ile do but the heatsink is a tight comfy fit on the TRAXXAS SLASH 4x4 with velinion motor
No comments. Reply..
Overall Rating
Evgeniy
1 likes
Value
Quality
Like it?
www.link www.link , со своими www.link www.link на все 100pcnt. можно www.link на www.link и www.link www.link www.link
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
