I have this ESC with the motor Turnigy 600 4030 1400Kv (for a HK600).
I have problems with the ESC, it starts very fast.
I've programmed soft start but still the same. Do you know what could it be?
Tengo este variador con el motor Turnigy 600 4030 1400Kv para un HK600.
Tengo problemas con el variador, arranca muy rá*pido.
Le he programado arranque blando pero sigue igual. ¿*Saben que puede ser debido?
I received the controller , when I plug it to 6s batt,
Heard a series of 10 beeps,sounds the same.
I have no ability to control or program the controller,
Servo and motor did not respond.
every few seconds those 10 beeps that sounds the same
What should I do?
received this esc. Set the Lipo cell number to 3 (manual says 1 short and 6 long tones). Using the esc runs a part of a second and then stops working. Noticed that the 1 short 7 long beeps option (manual) doesnt exist.
Maybe wrong manual for the number lipo cell. Does anybody knwo where to find the correct manual? The one in the files section found is wrong..
The manual seems same as HobbyKing SS series.
HK SS series has bad manner to reinitialize after several seconds after throttle is off (it beeps just as on startup). Untill initializing is finished you can't start the engine again. I'ts very dangerous when landing.
Can some one check if it has same reinitializing problem?
eh, this small thing for 180Amps??? The AWG12 wire alone (2x 10cm) will heat with 36W at 180A. Assuming 1mOhm FETs inside, the ESC will heat with about 70W at full load. A heatsink of more than the double size has about 2 degress/Watt, which would mean that it heats up about 140degrees (Celcius) above ambient. You'll really need excellent cooling, meaning really strong airflow!!! I'm gonna buy one for testing!
I recieved my esc I intalledit ion my formula 40 airplane I really need to set the timing properly for a INRUNNER that goes 32000 rpm It says here that the stick programming manual can be foundn under the " files tab" WHAT THE HECK DOSE THAT MEEN I see no files tab anywere under this page were is it and whjat tab are they talking about? Cearity guys Mr hobby king Please be more clear on what your talking about please help us understand what you meen with dificulty and frustration If anyone an answer my q it will be greatly apreciated Thank you :)
My apologys It was my computers fault not hobbyking The files tab was not beeing displayed properly on my pc do to a extremly slow loading It has revieled itself now Sorry for the complaint mr hobby king :) The problem is now resolved ( i need a new pc :)
Ok all set up and its a complete failure ive tryed sevral difrent cutoff setting and difrent timings and difrent puls rates and all the same result It cuts out at about 22 amps Maybe its faulty Who knows but it will not work perhaps it cant handle the rpm If anyone has advice on how to fix it let me know please If it gets working ( cant see it ive tryed everything ) then ill post another coment to let you know If i do not then you know it was never fixed I guess ill be going back to good old reliable castle creations
This 190 amp esc is a 22 amp esc it cuts out as a over amp at 22 amps Faulty or just cheap? I don't know