USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
There should be a warning with this upgrade. The screws and spacers this comes with will dissapear within a few minutes as this part cannot be tightened up all the way to allow for proper turning. The screw and spacer will fall out of the bottom of this C bracket and will be MIA.
Can we please see some spacers and bolts that actually work for this part or atleast stock some extra spacers specifically for this metal part? Thank You! BTW the plastic spacer replacement will not work for the metal part.
This video is referring to the Monster Beatle and not the Rally Extreme.
The part# 30706 screw when using the upgraded metal C bracket are too long and when tightened up will cause the wheel drive to lock in place. The screws (110BS-30827) are roughly 3mm too long. This is a major fault with the upgraded part for the Extreme Edition drifter. Might work for the Beatle but not the Extreme.
The only fix for this would be to shave off the 3mm on the screw to avoid contact with the wheel drive when fully screwed in.
Thanks for the video :)
Don't think HK has those bits in metal, but you can use these "110BS-30706" in their place without issues. They are plastic instead of metal, but so far the plastic ones I'm using along with the front metal C-hubs haven't caused me any problems yet...
You get the scews, if you buy the inner part www.link but you can still use the old ones. I had to grind them a little with proxxon, so thay didnt rub on wheeldrives.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg)
when this item restocking ....? 
