NTM Prop Drive 2836 Series Replacement Shaft

 DAJARAJA 305 points

yeah cecca no probs.copy/ paste online Brushless Motor, Shaft / Pusher Conversion . TheRattleSnake3145 .his vid will pop up (youtube)the vids really an upgrade from 3.17 to 4mm shaft.the turnigy 3700kv he is using for conversion has the same length shaft as the 3200kv.yes hes using 3536 shaft (which is longer by 5mm)but you will notice everthing fits perfectly without modding(c clip etc)which i cant make that call about this shaft unless someone out there kindly gives a measurement on how far the c clip groove is from the grub screw end (better to go with what you see).im sorry i cant help anymore than this but hope you find a solution .actually just watching the vid again gave me the solution to my motor shaft replacement problem so sorry and thanks cecca goodluck happyflying.

 DAJARAJA 305 points

update- sorry he has the ntm sitting on bench but says he using a turnigy sk 3536 shaft(i think)which is only 58mm in length.dont cred im happy to help if i have plus you helped me also cheers:)

 DAJARAJA 305 points

yes and no, check your hk message inbox

 cecca 7 points

yes or no? where do i find the shaft for 2836-3200?

 DAJARAJA 305 points

hey cecca,this question was a while ago. so had hard time trying to think what i wrote.so had to go to hk forum to see what i wrote to ozkiwi(lol).ok here it is (yes and no)you need to pull your turnigy 2836 apart to see what the shaft it is,it should be a 4mm shaft(4mm dia hole bearings) running through the motor than dropping down to a 3.17 shaftend.and its a 3536 910kv ntm propdrive replacement shaft that will work but youll end up with a 4mm shaftend instead. (yes and no)this is all i found on hk that was a direct fit for the turnigy sorry keep looking if you dont like it.here is the vid on you tube check it out Brushless Motor, Shaft / Pusher Conversion . TheRattleSnake3145 goodluck.

 cecca 7 points

Thanks. It is correct, 2836-3200 shaft goes from 4mm to 3.17 and it is 55mm in lenght. But, why do you say to buy a 3536 shaft instead of this?

 DAJARAJA 305 points

hey ozkiwi the shaft diameter spec for your motor is 3.17mm

 xefirot 71 points

Yes, it is. I'm using it with a Turnigy D2836/9 950KV Brushless Outrunner Motor and motor dimensions are same.