Planes & Parts
Helicopters & Parts
Multi-Rotors & Parts
Cars & Parts
Boats & Parts
Bikes & Parts
Scale R/C Tanks
FPV & Telemetry
Batteries & Accessories
Chargers & Accessories
Robotics & DIY
Servos & Parts
Radios & Receivers
Gas/Glow Engines & parts
UBEC & Regulator
Hardware & accessories.
Clothing, Gift & Acc.
USA warehouse now open. Our USA warehouse is now open!
Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Specs. RPM/V: 1350Cell Count: Kv 2s~3s Max.current: Lipoly 10AMax Watts: 120w No Load Current: 0.3A/7.4V Dimensions: Φ28mm×16mm Shaft: 3mm Weight: 26gMax Thrust: 245g
PRODUCT ID: 244000007
Max Current (A)
Max Voltage (V)
Shaft A (mm)
Length B (mm)
Diameter C (mm)
Can Length D (mm)
Total Length E (mm)
Update/Add my own data
The prop saver studs seem pretty short and have no screw heads from the band to hold onto. I'm having a very difficult time mounting a prop to this motor. Does anyone have any suggestions? Thanks
I mount them with a flat head screwdriver. It's not that easy, but it works.
Yea these prop savers hard hard to install... they barely fit onto the shaft and come lose easily...
1 points - 4/27/2013
can you use this to the teksumo? what prop then?..
what about quadrotor with these motors yes or no
You can only use prop saver with these motors, so you better buy something else that you can secure the prop to the shaft with a screw.
The screws were not included in the motor.
Does anyone know the size screw this is?
This is a BRUSHLESS MOTOR 101 Question.
The shaft appears to come out the back side on this motor. On others the shaft is on the right side. Yet the motor mounts are identical. The fact that they are identical tells me this motor was not dreamed up out of the blue, but that there are certain standards. By any chance can the shaft be turned around after manufacture. There is a set screw holding the shaft in and and slip ring on the other end.
This type of fitment on this class of motor is the most common......it is not designed to be reversed.
BEST ANSWER CREDIT AWARDED
Thank you Scott,
The question was actually for another motor, which you answered.
"Fitment" New to me and I'm a 65 year old engineer. I looked it up. Wow. What a useful word. Thanks. That is worth a double extra points.
299 points - 1/7/2013
does this fit 5030 propellers?
these motors are stupid, the shaft is too small and the prop savers slip off easy... i dont recommend these motors for any type of build...
What is width of the motor mount?
2 points - 5/8/2012
Does anyone have experience with this engine?
windy , plane weight 550g need a little bit larger engine for god 3D
Tieto vyrobky som este nikdy neobjednaval ale boli mi doporucene od mojich kolegov,tak dufam,ze budu dobre fungovat aj mmne k mojej plnej spokojenosti.
.....click here to see all reviews