USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Specs: Constant Current: 100A Burst Current: 140A Battery: 2-6S Lipoly / 5-18s NiXX BEC: 5.5v / 4A Motor Type: Sensorless Brushless Size: 67 x 32 x 23mm Weight: 99g
Programming Functions: Battery Type: Lipo /NiXX Brake: On / Off Voltage Protection: Low / Mid / High Protection mode: Reduce power / Cut off power Timing: Low / Medium / High Startup: Fast / Normal / Soft PWM Frequency: 8k / 16k Helicopter mode: Off / 5sec / 15sec (Start up delay)
Hello Fai2 check that the trottle is not inverted (try with full trottle) check that the trim is low enough Usually one of them is the cause. You can also try with another ESC Enjoy flying
I recently purchased an HK 100 amp SBEC speed controller. I tried it on the weekend and altough it plays the 'power up' warning, it will not actually run the motor. I contacted live chat for a manual - there isn't one. I have just read that it is programable - do I need a program card? If so which one and how do i get hold of a manual? The battery is fully charged and a much smaller ESC actually runs the motor so i know there is a problem with the new 100A ESC. Any suggestions?
Cannot find a manual anywhere,anyone able to help? It should work fine without programming,a programme card is if you wish to change the parameters of the ESC,if you wish to do this then use Part#SKU: 9261000016. Not sure which radio you are using but make sure the throttle trim is right down to the bottom,if it still does not work increase the "travel adjust" on the throttle channel of your transmitter if it is able to do this,adjust it from 100% up to 120%,if this still does not work try reversing the throttle channel on the transmitter.
Hello, my MX2 was to test a battery with nano 4s 70c/130 2700 and one of the capacitors 80A ESC melted the connector pin, tell me someone knows what could have happened to this place, ESC What else could I buy here site for my MX2? Thank you!
Hello Na brega sorry to hear that.This ESC is a cheap one but should be working fine with this motro and battery. may be you can fix it? Always pay attention of not havint the heatsink toouching the soldering of the cables. Usually there is very small gap between the parts. Turigy plush is a good one, only a bit more expensive Enjoy flying
good evening. I bought the following esc: HobbyKing 100A ESC 4A UBEC and the following engine Warhead 3545-1850KV EDF Motor 90mm when at full throttle the engine comes into strong vibrations. I use a 6s lipo, perhaps the 'esc need to be programmed. the program card for esc is recommended you up to 80 A, you have a program card for the 'esc 100 A I purchased
hi . is this good for the beaver with 4248 ntm motor and 6 high speed ,digital standard servoes and 15 x10 prop .? thx
Customer Reviews
Overall Rating
3/1/2013 Antonio
0 likes
Value
Quality
Like it?
Not sure what happened with the first one but hobbyking made it right and it is powering Alloy DPS Series 70mm 10-Blade EDF unit with 2200kv Motor - 1900watt. does not even get really warm. First one went when the motor went and I still had full control and landed with no motor. Very happy. I will buy more.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
