Overall a nice anti-rotation bracket. Better than the Align plastic one, the canopy screws stripped the plastic after a couple of removals. The canopy screws fit well and hold the bracket snug to the frame. The anti-rotation part of the bracket is a little thin and flimsy but time will tell if it holds up.
I was impressed by the weight of the bracket. Being metal I expected it to be significantly heavier than the original plastic one but the bracket itself is almost exactly the same (about 6g).
The thin upper section makes me wonder how it will stand up to some real stresses but I found it difficult to bend in my fingers so it is likely going to be OK. Time will tell for sure.
The upper section is screwed into the base with two screws. I removed the screws to check for fit and thread-lock. The fit was good and although no thread-lock had been used the screws were firmly tightened. I will be adding thread-lock when I reassemble because of my own paranoia.
The base and top section are engineered to fit together very well and overall it looks nice.
Unfortunately, the bracket I received had a badly cut thread in the base where one of the canopy screws fit. The result was a very loose fit screw that I could not get to tighten. Hence, the quality only 2 crowns. I was probably just unlucky and will not be sending it back due to the cost. For the present I am stuck with my original plastic one but, given the price, I will try again on my next order. That is assuming this doesn't look like a recurring problem..??