USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Dimension: 18mm x 17mm Weight: 13g /0.45oz (not including mount); Diameter of shaft: 2.0mm Length of front shaft: F7.5mm Kv: F1850 Unload current: 7v 0.35A 10v 0.43A
20mm-24mm diameter motors can be fixed Weight:13g(no spinner) Space between the fixing holes:16.6mm(M2 M2.5 M3) Big Gear:64T Motor Gear:11T-16T To work with AEM 12S motor,10V 19.9A ,it produces 1027g thrust
The shipping weight is just that,by the time the item is put in a in a box with packing material etc so it arrives in one piece the weight creeps up,approx 70/75g for a box and packaging is not out of the way.
me again.. also does it have any connectors on it or am I looking at wiring my own? hoping it will work for a 700g GWS PT-17 bi-plane with 3s 2200's
as in my previous .. looking for ESC advise too
Hello, What can I do if the 64T gear comes out its place when starting to run the motor? I put it again in place with a little CA but didn't work. Thank you.
Happens to me on a similar motor. I ended up putting a few washers and a spacer between the prop and the gear. This way the gear simply cannot move forward. Good luck.
Just installed this motor on my 2 lb. powered glider. Almost vertical performance on a 3 cell lipo and 13X8 prop. Pulls about 15 amps while only getting warm. Great motor, good quality, and Good price.
2 comments. Reply..
Overall Rating
viladavila
15 likes
Value
UNRATED
Quality
UNRATED
Like it?
Just tried it out on my gws ss and did not even use full throttle until just on ocassion because it was to windy for the SS. It just took off like a rocket when applied WOT. Fly good with just 1/4 t. Using a 2cell 1300 lipo. Pleased with the perfomance! Just think the wires are too thin.
No comments. Reply..
Overall Rating
thierry123
312 likes
Value
UNRATED
Quality
UNRATED
Like it?
genial pour le formaza de chez GWS parfait rien a redir. sa mont a perpet pour un prix ridicule
Motor is great - can pump out 200watts without getting too hot, though wouldn't want to run it on full throttle for too long pulling >20amps.
Does a good job pulling 600g scratch built glider into the air at near vertical using 3s 1200mA lipo.
CONS
Big negative is the main shaft and nylon gear don't seem to be readily available. Seems a shame to throw away a perfectly good gearbox for the sake of a busted gear or bent shaft.
No complaints with the unit, it works fine so 5 stars for it. As for usefull information about it I'll only give 3 stars. We need to know the weight of the unit, not some individual part of it. The 13 grams stated is meaningless and just deceptive. I was certain it was when I ordered it but couldn't see the true weight anywhere. So here it is complete unit as it comes without conectors, 42 grams, if you pull off the rubbery spinner cap it drops to 39 grams.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
.jpg){kind=avatar}
