USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Spinner suits motors with a 5mm shaft. Diameter is 56mm Lightweight spinner uses a hex-bolt to hold cone in place and lightweight alloy extruded and machined. Weight: 63g
Spinner for 5mm shaft is a very nice product with a suplim finish but: drilling a 5mm hole in a 8mm aksel is ok, but when the hole goes under the thread there are less than a 0,5 mm alu left. Sorry but it will break for sure, i have tried it twice. A pety for this nice spinner
Customer Reviews
Overall Rating
Frank Manders
likes
Value
UNRATED
Quality
UNRATED
7 thumbs up!
The mounting axle is a soft type of aluminium. I fastend it for the second time and the axle snapped.
Will not buy again.
No comments. Reply..
Overall Rating
Stephen Barton
likes
Value
UNRATED
Quality
UNRATED
6 thumbs up!
I tried to use it on a Turnigy 1200 kv/volt (B36 56 09 1200 kv) but the taper of the shaft and the base plate do not match well and you need to manually adjust the angle of the plate to get it to 90 degrees - it does not seat by itself. As such it is simply not possible to have it perfectly symmetrical to the shaft and at half power on 3S and 10x6 prop it vibrates excessively. Unless you are using a larger prop at lower revs I would stay away from this unit.
No comments. Reply..
Overall Rating
Raf Golsteyn
likes
Value
UNRATED
Quality
UNRATED
3 thumbs up!
Unable to line up, just like Stephen states. Always resulting in unbalance of prop.
Poor product, such a pitty.
No comments. Reply..
Overall Rating
Customer
32 likes
Value
UNRATED
Quality
UNRATED
2 thumbs up!
Attention trs fragile, l'axe se casse facilement ds qu'on serre un peu ferme !
No comments. Reply..
Overall Rating
modelvincent
14 likes
Value
UNRATED
Quality
UNRATED
1 thumbs up!
Attention, l'axe est extremement fragile et a cass au premier serrage...
A ne surtout pas recommander, malgr une tres belle finition le dfaut de conception de l'axe fait que ce cne est inutilisable.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
