USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Not a question but a solution. If youare finding that your comet is stalling and rolling check out the weight in the front of the nose. I found that mine was glued on on one side and not centred which caused the wing to drop and stall when landing (need to keep up the speed) I re-glued the weight central and now do not have a problem. Its a great plane, I love it, now if only i could land it without crashing..........
forget the screws. I have four on my skyfun all glued. I have placed one at the front of the fuselage and one at the rear with one on each wing. Save on the wear and tear of landing. Also very easy to replace if they fall off, just glue it back on again!
ive been cutting the pins off the other side and hot gluing them on. They work really well. there arent any holes to fit screws and that method wouldnt work as well as gluing anyway
You but them under the wings so when you land if your wing falls it doesn't s****e on the ground great for when you belly land with no landing gear as well just put under the bottom of the fuselage where the wheels would usually go.
Good protection for your aileron servo and control linkages on aircraft without landing gear. Glue them into the edge of the wing, and it helps protect them.
Customer Reviews
Overall Rating
seawindep
24 likes
Value
UNRATED
Quality
UNRATED
2 thumbs up!
You can glue it... screw it... Not only on the wings tips, but on the aircraft body as well. Usefull!
Fantastic stuff. This is something that you should have, will save your wing from serious damage. A small price to pay, than having scratches on you wing. Can be used on the tail section as well.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
