Prop adapter w/ Alu Cone 1/4x28-3.2mm shaft (Grub Screw Type)

Total of 3 discussions.

maukabud

408 points - 6/11/2011

anyone know the output shaft diameter...in mm? Is it 6.35mm?

Pushrod

585 points

yes it sis 6.35mm the props i was using were 6mm so had to widen hole slightly or just tread it on.

BEST ANSWER CREDIT AWARDED

maukabud

408 points

Thanks!

Wayno

11 points - 2/20/2011

Will these work with the Clouds Fly plane?

ferulik

6 points

this is for 3.2 mm shaft,Clouds Fly motor shaft is 3 mm in PNP and ARF version.If you have original motor it´s will no work.

vaida32

93 points - 5/22/2009

Is this the correct adapter for the 3.2mm shaft motors such as the HXT 2835 (380S) 2700kv Brushless Inrunner?

ay6810

237 points

It should be if the specs are correct. Just remember to tighthen those grub screws and loctite them well!

helicopke

110 points

yep, it helps plenty grinding a flat on the motor axle too, then loctite grub screws.

Pushrod

585 points

If you are grinding a flat spot on motor shaft make sure to cover vent holes to stop filings sticking to magnet poles.

Customer Reviews

Create an account

Overall Rating		Tony Loeffel 459 likes
Value	UNRATED
Quality	UNRATED

1 thumbs up!

Keep some extras handy as they can deform easily when impacted - lake a crash for example.

No comments. Reply..

Create an account

Overall Rating		Tropic 28 likes
Value	UNRATED
Quality	UNRATED

1 thumbs up!

light and nice, hope it fits well with screws..

No comments. Reply..

Create an account

Overall Rating		__HaKK 364 likes
Value	UNRATED
Quality	UNRATED

1 thumbs up!

I prefer these cone type prop adapters to the collet types as they only require one tool on the filed (e.g. a hex drive) to change your propellers. To keep them well on the shaft, just grind a flat on the axle with a dremel and don't forget to use thread glue like Loctite 243 on set screws.

No comments. Reply..

Create an account

Overall Rating		omaha_rc_flyer 47 likes
Value	UNRATED
Quality	UNRATED

1 thumbs up!

4 Stars because it's not the correct size. It's too small for 3.2 MM shafts and will have to be drilled out a little, if you plan on using it on 3.2mm shafts. I used a 1/8" bit which seem to work fine for me.

2 comments. Reply..

Create an account

Overall Rating		xxrexxmyxx 14 likes
Value	UNRATED
Quality	UNRATED

Like it?

Attention, prendre en compte qu'il s'agit d'une pice assez volumineuse (35mm de long) et lourde (11,8gr). Ces informations manquent dans les caractristiques! Dommage.

No comments. Reply..

.....click here to see all reviews

Prop adapter w/ Alu Cone 1/4x28-3.2mm shaft (Grub Screw Type)

Propeller adapter. To suit;3.2mm Motor Shaft.1/4x28 Propeller Shaft.Alloy adapter with grub screw and alloy end cone. 1pc Only. PRODUCT ID: GS0163M

Propeller adapter.

To suit;
3.2mm Motor Shaft.
1/4x28 Propeller Shaft.
Alloy adapter with grub screw and alloy end cone.

1pc Only.

PRODUCT ID: GS0163M