USA warehouse now open. Our USA warehouse is now open! Low cost shipping and an ever growing variety make ordering from the US warehouse even better value!
Spinner suits motors with a 3.17mm shaft. Diameter is 30mm Lightweight spinner uses a hex-bolt to hold cone in place and lightweight alloy extruded and machined. Weight: 9g
Just wondering what the exact diameter of the base of the collet adapter itself is. Reason I need this info is I'm hoping to replace the collet on this with one of mine which fits a 5mm motor shaft. (Of course this is assuming that the collet on this is NOT "built in" but rather can be removed.)
I've been having a heck of a time finding a spinner this size (30 to 32mm) that can fit a 5mm motor. As we all know this size of spinner is commonly made to fit 3 to 3.2mm shafts so I'm hoping that I can adapt this one for my needs.
I'm guessing that the base of this collet adapter is probably smaller than mine and so I may have to drill out the actual hole in the back plate itself to substitute it with mine.
i might have some bad news for u....although the collet itself is removable from the spinner back plate, the collet, along with the hole in the back plate is tapered from 7mm at the base to 6mm
You should rather fit a prop to a motor, not motor to a engine. 13x8 I think some 1500kv motor and about 500w. I think a 500w engine would have a 4mm or 5mm shaft not a 3.17mm - so, first you have to find the motor.
I was not able to press it on my Turnigy B2835-3900 with a 3,17mm shaft. I tried to drill it up to 3,2mm. Then I was able to easely press it on the shaft. I tightened the spinner and sadly discovered that the spinner makes heavy vibrations. My advise after this: DON'T try to drill it up. It will only destroy the spinner sentering capability. This was my experience with this spinner.
Customer Reviews
Overall Rating
rcwck
227 likes
Value
UNRATED
Quality
UNRATED
3 thumbs up!
I'm using this spinner on my Demon pylon at 183plus mph with a 4.1 x 4.1 prop. Straight and smooth with no vibration
No comments. Reply..
Overall Rating
XBOBBY
45 likes
Value
UNRATED
Quality
UNRATED
2 thumbs up!
Great stuff, spinner it almost perfect ture. adding small amount of tape inside of spinner makes it perfect. will be getting more of these. also got the 3mm and floding prop spinners, those are great aswell. Will by again.
Copyright 2012 Hextronik Limited.
The HobbyKing.com®, OrangeRx, Turnigy, Durafly, nano-tech and other brand logos and names are trademarks of hexTronik Limited.
All rights reserved
.jpg){kind=small}
