Turnigy 1000mAh 3S 20C Lipo Pack

 mrdrob08 12 points

Yes and it will work flawlessly

 mena142 740 points

It depends entirely on what prop you plan on using. At 1580kv and this 3S (12.3v fully charged) battery, I'd go with some 8x4 prop to keep the amps low. Keep in mind that the max amp draw for this battery is 20a (20cx1a) but if you draw that much it will get hot and reduce the lifespan of the battery.

 Colby 48 points

What motor do you have in your plane?

 Roger 2250 points

You could get more answer by posting at the 9XR discussion board. LOng press the left button and scroll down to the Default Sw menu. From here you can set whatever switch position you want as the default. I don't really get what your 2nd question is but let me try. You have a Mode 2 transmitter and the right stick is spring loaded so it comes back to the center position. Your throttle is the left stick.

 Ayberk 21 points

You must have calibrated it wrong. Hold down the left button long. Then go right tot he calibration menu. Then put all the sticks and turny knobs(pots) in the middle position even the throttle at 50%. Then move all the sticks and knobs to their maximums and minimums. Hope I helped.

 Jonathas 60 points

Hello friend. It is compatible with E-Sky HoneyBee Cpx. The original battery is a Lipo 11.1V 1000mAh like this. :)

 Jonathas 60 points

Hello friend, the Big Lama original battery is a 11.1V 800mAh Li-polymer battery. The battery Turnigy 1000mAh 3S 20C Lipo Pack can be used in Big Lama without problem, only verify the Pack Size: 79.5 x 36.5 x 17mm if fit in your heli battery support.

 CADERTOT 65 points

It could have a bad cell or could be that your motor Esc combo pulls to much power and you need a higher rating mah and c rating

 praneeth 9 points

your battery it was while death. u can change your battery. when you buy a new battery please think about thise one>>>>>> if you charge first time your battery and give a big Amp for your battery then you can use your battery too years.don't connect a big voltage without type battery MAX voltage then never fail your battery, never high heat your battery. u can see good a fly... keep remember.

 mena142 740 points

It's too big and heavy. I recommend a 800 mAh

 mena142 740 points

A LiPo mod is very common, and it will work. You just have to be 100% sure that you plug negative to negative, and positive to positive or you will destroy some internal components the moment you plug it in reversed. I would recomend tho, that you get one of the "transmitter packs" HK sells given that they fit on your unit.

 Michael O' 7 points

Thanks for that, you are very helpful! - I did not realise that HK sell a pack for their transmitters. I will now go and look. M

 knokke 5 points

On a batterypack you always use the female plug, this way you can avoid an accidental short circuit.

 Paulo-ca 1 points

You will need to replace the battery connector to match your ESC connector. If you keep the bettery connector you need to use the JST connector in your ESC

 Felipe 2 points

Você vai precisar de substituir o conector da bateria para corresponder ao seu conector ESC. Se você manter o conector bettery você precisa usar o conector JST na sua ESC

 Viper_one3 10 points

You will need a female JST plug!

 VinayakR 2 points

Patience is a key here stock will back with in 14 days as HK said .Mean while you can also subscrib to STOCK ARRIVAL ALERT

 mena142 740 points

Some day in the future.

 mena142 740 points

You should charge this at 1000mA to prolong the life of the LiPo, but it can also be charged at 2000mA for half charging time, not more than that.

 Rustler8 17 points

I charge mine at 1 amp.

 MikiLa 2 points

It's easy. You should charge at a low rate if it's possible because of the material (it will last longer). The standard maximum is 1C. This means that the whole volume of the pack will be loaded in 1 hour. If your lipo has 1000 mAh, you should charge at 1000mA -> 1A. You can charge at a higher input, but i don't recommend this because of the lifetime of the pack. Maybe it will overheat, followed by an explosion in the worst case.

 mena142 740 points

You should charge at 1A (1A = 1000mA)

 Dawid 13 points

A is Ampere *******en.wikipedia****/wiki/Ampere

 MikiLa 2 points

It's easy. A is an Ampere. This is the most common definition for the amount of energy (electricity) which flows through a wire. If you charge at 0.1 A, you put in 0.1 Ampere in one hour. You should charge at a low rate if it's possible because of the material (it will last longer). The standard maximum is 1C. This means that the whole volume of the pack will be loaded in 1 hour. If your lipo has 1000 mAh, you should charge at 1000mA -> 1A. You can charge at a higher input, but i don't re

 jonacrazyplane 52 points

1A = 1000mA

 Sebastian_Hely 45 points

Yes you can.

 Rustler8 17 points

I think you could, but the wire is pretty small.

 Fe Crystal 16 points

you can change it to xt-60 plug at least that what i did with my bat

 mena142 740 points

It depends on your setup...search for MotoCalc and calculate your setup.

 Paulo pilot 4 points

model aircraft in this configuration setup, depends largely on the respect and weight, was already in flight ± 20 min in a cesnna of 0.450 grams

 kameshop 2 points

Difficult airplane have difficult time to fly. Defend the wind and weight, ... etc. But in normal wing 80cm have 5-6 minites to fly

 flyerBob 3 points

i own 8 of these bad boys and they perform outstanding in all weather conditions and they really take the abuse, great price, great quality, nice hobbyking

 claudioouem 6 points

acredito que vc terá em media de 15 á 20 minutos de voo.

 Vbrugman 22 points

Depends of your flying style, but I think approx 10 - 20 minutes. Enjoy

 Daniel 5 points

YEah I'll go with the 10-20 minutes answer

 HEATEDHAT 33 points

I have this plane. I run a 2200mah batt 4s 40c. I get 14min od=f flight per charge at 75 percent throttle

 normal_nick 22 points

For ESC you'll need JST female, for battery - male

 steve 1 points

female connector

 Raphael 8 points

I recomand you to buy a bigger conector and avoid use these JST conector for this size of battery.

 mena142 740 points

The female side always goes in the airplane side and the female on the battery side, hence, you plug the battery to the airplane and not the other way around.

 claudioouem 6 points

a bateria terá a femea e vc precisara do macho.

 Barry 1 points

Esc JST Female

 Drew2Blue 3 points

That connector is my problem. Any links to how to replace connectors for dummies? Need it to fit JPOWER L-39 PNP bought from HK.

 pr0fab 440 points

Sorry sir! Bad click!

 Adam 229 points

Yes. 1C is prefer and 2C is maximum Ampr charge! www.link

 Gary Toh 31 points

This battery can supply up to constant 20C, technically speaking, i can charge up using 20C but risk of explosion during to high temperature built up. Unless i have a very effective cooling system. To be safe, you can charge up to 5C depending on the charger capacity and ventilation. Hope it help.

 Lennyluger 16 points

Just about any charger that can charge a LiPo. Here are some suggestions:
- HobbyKing ECO6 50W 5A Balancer/Charger w/ accessories (product id: ECO6)
- Turnigy balancer & Charger 2S-3S (product id: Turnigy-3S)
- B6-AC Plus - Charger/Discharger 1-6 Cells Dual Power (COPY) (product id: FY-B6AC)

Remeber to make sure you have the correct plugs that fit the battery.

Regards,
Lenny

 TechnoFinder 126 points

i use Turnigy Accucel-6 50W 6A Balancer/Charger w/ accessories

 flyzmilez 39 points

Just about any lipo charger/balancer that hobbyking stock will work on this battery and they start at less than $5 !

 Twimnox 15 points

You can use any charger that allows you to charge at a maximum of 1C rate (1AMP)

 Vivek 7 points

No the discjarge is too high..

 pompebled 10 points

Basically yes, but only if the manual states the TX will handle up to 12,6V (a fully charged 3S). Jan.

 rls0022 10 points

If the radio supports 12 volt it will work as it will only draw what in needs the battery wont force current the tx does not need.

 yrider426 4 points

You just need to be careful. Short answer: Yes it will work. But it is possible that the battery can supply too much current and fry some of your electronics. That is the risk you run. Unlikely, but possible.

 Vivek 7 points

No please dont.. its not rated for such high current...

 reini1755 26 points

this lipo can do 20 A contiouse. i would prefer a nanotech with 25c

 joeham 8 points

No, better use >= 25C Lipo

 magnusEl 1214 points

Does the motor pull that current, or is it rated 23A Max?
If your motor draws less then 20A then it is OK, but you have to meassure the current to be sure!

 gvertical 22 points

very good lipo

 Ivan 3 points

Yes, can. If you do not fly at full thrust for more than 20 seconds.

 OrlCorp 14 points

You can, if full throttle is rarely used and not for long.

 Olga 1 points

Yes you can I used whit 30amps

 Igors 11 points

1000mAh x 20C = 20A Maximum!!! Good luck!

 pyropete 23 points

Pack Size: 69 x 35 x 17mm

 k.smith459 52 points

no but this www.link :)

 tedesco 12 points

No!! Its 2mm wider than the bay!!

 zeroskin76 60 points

sometimes items are sold in more than one wherehouse and these are sold out of all them unless out of stock in one at time

 Salzdetfurth 9 points

Da ist eine ganze Auswahl vorhanden. Einfach mal runterscrollen.

 Karl 5 points

warte seit 2monaten (11.3.)auf meine bestellten lipos u bin mittleile sauer. canceln kann man die bestellung nicht - da wird man zum support verwiesen der aber nicht erreichbar ist.....

 H-KING_SCOTT 5160 points

Yes this will suit the Wilga-2000

 Joel 17 points

Thanks

 yellowpasta2000 6 points

yes its suitable!

 tornadorc 208 points

It all depends on the traxxas radio. How much current does it require. How often do you use it.

 Harald 33 points

THE RED PLUG IS AN JST PLUG THE WHITE ONE IS AN XH BALANCE PLUG. YOU NEED A FEMALE JST PLUG WHITCH IS SOLD HERE IN THIS SHOP TO CONNECT IT.
I AM WORKING WHITCH THE SAME LIPO WHITHOUT ANY PROBLEMS

 Vladimer 20 points

It Comes With JST Discharge Plug