Turnigy 1000mAh 3S 25C Lipo Pack

 WTWUK 1359 points

Yes. I use the same ones.

 tommy2toes 2084 points

i would not. as it is a brushed motor you can find a nano tech or zippy a lighter lipo and then yes but it needs to be within about 20 grams up or downand be sure to mark a center of gravity and you can use a bigger battery but only for normal flying. Not 3d if your doing 3d you need to use the recomended wieght for proper flight. hope this has helped happy flying.

 Lsugui 13 points

Tommy Thanks for you prompt reply so CAN i use bigger battery such as 1300 mah ? For exemple to extend flying time? But i cannot fly 3d?

 tommy2toes 2084 points

i was thinkin 1150 or 1200 you really dont want to push past the strain level of what the servos and esc can pull. example: when you dive 3d and pull out last min theres a eccesive amount of wieght and torque you dont want to use a bigger battery than what that would equill. 1300 will probally take a little more gas to lift and thats going to strain the esc as well so if you use a 3 to 5amp ubec you can otherwise try 1150 or 1200 be sure to mark that cg before the change and make sure to get it to sit like that with the new battery. happy flying

 tommy2toes 2084 points

i would also concider a higher c rating if your going to be using more throtle. to help have less battery puffing

 Merlin Power 85 points

It has the wrong plug on it. You need one with a yellow XT50 connector. Also 1000mah is a bit small you would only get a short flight time.

 customer:*5* 9 points

Yes you can but you will just have to change plugs (you can put for example 4mm gold connector on the ESC and the battery). But You should buy two or three to fly 20-25 min. (or choose one with a bigger capacity like 1300 or 1500 but it will be heavier)

 eben_r 34 points

Hi..i have a XT60 connector..can i solder and use it?

 tommy2toes 2084 points

yes you can use xt60 as long as they match it dosnt matter what kind of plugs just match pos neg

 BossJay 158 points

Yes, you can use this Lipo. But,with 1000mah, shorter flight time.

 MohElg 40 points

how short ?

 BossJay 158 points

With good throttle control, Flight time around 10-12mins.

 Blade Boy 116 points

I use a 2200 mah battery in my floater and I get 25 minute flights. Plus I found that the plane balanced pefectly with the 2200 mah battery. Yes you can us it but you will greatly reduce your flying time.

 Kencono 8 points

you can use this lipo but the flight time is only briefly

 helikido 6 points

I would go a bit higher when it comes to MAH since your flightimes might be a bit too short.

 tommy2toes 2084 points

no the balance would be all wrongyou need a 21 or 2200 mah or you can run 2 of those 1000mah together in sequence.

 Alonso 18 points

every 4 flys

 ANDY in c.a.p 329 points

yes it is vary nessecary to balens any lipo iv flown on an unbalenst lipo it dosn't werk

 Jonathan 87 points

You know that when you balance the lipo also it's charging. you can only balance the lipo and it already for use.

 Tomasz 5 points

Yes becouse if u don't balance full pack will have 12,4v after charging but single cell will not have equal voltage. And its simple way to overcharge some cell and destrou the package...

 Kencono 8 points

yes it is vary nessecary to balance

 Wagner 14 points

Sim de preferencia a cada 03 veses de usos, equalize a bateria.

 helikido 6 points

Every single flight if you want to keep it healthy and prevent it from getting puffed up.

 tommy2toes 2084 points

most chargers have built in balancing. i bought the hobbyking 420 charges 2-4s built in balancer $22.00

 tommy2toes 2084 points

sorry, to your quetion, yes it is nessecary to balance a lipo if you want to keep using it. tommy

 connor 19 points

1p means 1 parallel This means that it is a 3s without the need for a parallel conversion! 2p would mean that that battery is wired in series

 alex 2 points

That the battery is not wired in series. 1p = 1 parallel as it stands with out anohter batter. 2p = 2 parallel. For most battery applications at the novice/intermediaite level you will be using 1p.

 dhruv 103 points

It means that one cell is connected in parallel to another cell.

 hamzajaved780 13 points

Yes It does

 Herishi 40 points

I comes with the small red JST 2 pin connector as used on most FPV/OSD equipment.

 Uberfest 31 points

pode colocar ou substituir o plug, pelo que vc prescisar...

 redblur 8 points

yes it does,i recomend to change the original plug to a T-Connector style plug or the other one i forgot the name.

 Trevor 6 points

Yes, mini JST I think they are called, nice & small & light weight

 bandar 26 points

First, you must know these things about your battery:
1-the size.
2-the voltage.
3-the discharge rate.(Not so important, you can use battery that differ from yours in the discharge rate -5)
If all these are the same with "Turnigy 1000mAh 3S 25C Lipo Pack" it can be used in your heli.
Another thing may come in your mind "THE CAPACITY (1000mAh)"
Do not wary because if the previous points are matched with your's then try to find battery with maximum mAh so you can fly more time.
I hope thi

 Zachary 2 points

Yes, the work great in the Blade SR. I have been using them in mine for over a year now. I probably have 75 cycles on four of them with no issues. 8 minutes of flight time in stunt mode. Great batteries.

 Berkay 1 points

You can use in your helicopter. This is the great battery for this helicopter. Your flight time abuout 9-12 minutes.

 DaveE1 39 points

All lipos seem to be taking a long time to restock since more than a month ago. I wonder if the Tsunami in Japan may be affecting the supply chain? I read some factories making chemicals for Lipos were affected.

 Fossy 91 points

I am afraid that could take some time, because many, many people are waiting for these fine batteries. The best way is to set the email remember function and you will get an email as soon as the batteries are on stock again..

 sm6592 10 points

I've waited for 2 months. All kind od 3S lipos around 1000mah is running out.

 purdy 77 points

They just came in and now gone again. But my order is now on its way. Hooray.

 nunyabizniss34 17 points

Yes they can. I have 3 of them and the fit under the canopy just fine, no mods needed.

 Eric 16 points

You bet, just make sure it balances the same, the batteries may be off in weight enough. Move the battery or apply counter weight accordingly.

 tangran 144 points

Yes, you may use in E-Flight Blade SR, since I don't have this type of heli. even the plug connector is the samee as stock battery. JST connector

 tedharpley 88 points

yes if the tx takes 8 batterrys and it fits it will handle the extra voltage ...mr ted

 Oscar 72 points

i woudln't recommend it, lipo batterie packs dont really act like regular AA batteries

 Blue_Bird 43 points

If I were you I would use some type of protection circuit, if that asplodes in your transmitter, you can say good bye to it, and maybe your hand too...

 warthog 413 points

you can use it but I think that it is better to use a battery with more capacity, I have installed on my radio a 2620 mAh battery (Rhino), see the dimensions of the battery in the product description www.link

 petter 77 points

it comes with a 18 awg wire. How many amps it is able to transmit?

 po_au 641 points

too long. you'd have problem fitting the canopy.
I even find it hard to fit canopy with original 850 battery..

 schulzie 140 points

im going to give it a try, ive heard of larger size batts in the 250

 schulzie 140 points

fits perfectly on the trex 250, you just need to move your canopy holes back about 5mm.

 JBFLY 26 points

You must be using a larger canopy. The battery sticks out so far, that the bottom of the canopy will not fit around the bottom plate as it should.

 noddyflyer 31 points

yes they can,ajust holes in canopy fit real nice

 Alexandr 7 points

Excellent batteries! My plane Zoom 4D is simply not recognizable!

 darren 6 points

These are a little big for a trex 250,i do use them in my trex 250 but i had to put the canopy holes right at the end of the canopy to get it on.
hope this helps