Hi! I purchased three of those batteries for my TRex 500. The ESC as well as the other batteries I have use 4mm HXT connectors (http://www.hobbyking.com/hobbyking/store/uh_viewIte m.asp?idproduct=9283) I cannot slide the wire into the red cap, since the wire is a bit wider. How could I attach the HXT connector to this batteries? Or will I have to use an adaptor?
Thanks in advance...
what I do is first cut the read conector off now the # 10 wire is a lill bigger for the yellow conector so peal back a little wire and pull it to the sideand soilder the wire in the yellow coneccor and once you are done with that add soider to the wier you pushed out and soider it to the outside of the bullet connector and you are done :)..
Need some advise please.Bought three of these batteries. When i recieved them i tested them with the Lipo tester.The tester alarm went off. Battery volts unballanced. I charged the batteries on my E station Bantam chargers and tested again. All three showed unballanced again. Voltage reads between 4.16 and on all three batteries and one cell on all three reads 4.23v.Hovered each of them for three minutes on my Trex 500 and recharged them using 0.1A on the charger. After fully charged , they still showed unballanced and one cell in each battery reads over 4.2v. This is very dissapointing to have three bad ones. Is it safe to use them like this. How do i connect the batteries to charge one cell at a time?.
i need some help with this battery.When i balance the battery charging stops and the result is fifth cell 4,20 and the rest 4.05 till 4.10.
When i just charge it whithout connect the balancing plug the fifth cell shows 4.30 and the rest 4.17 ,4.18 ect.
It looks like fifth cell have problem and take more electricity than the rest.
In that way i have 2 choices,
First leave battery not fully charged or overcharge the fifth cell so the rest have normal gharge.The total volts are in the first choise 22 on the second is 22,5 .
my ballancer is hobbyking for 6 cell that cost around 20 $
One solution is to charge each channel separate.Then the balancing is perfect but it takes a long time.
Hope some one can help me
that happen to me one time but not so drasticaly on the difference of the volts. what i did was just to charge it on the lowest setting possible that my charger had. it took like 3 hours to charge it that way but all the cells balanced out at the end. now i charge it at the regular rate.
after 2 months battery canot fly 3d.Not enough power.About balancing you get what you pay.Accusel 6 or battery cell have the problem.
What i do is balnce the battery and then i charge each cell separate till get 4.20v