Cellpro Multi4, 4A 58w Multi-Chemistry Charger
Cellpro Multi4, 4A 58w Multi-Chemistry Charger
Copy and Share the Below URL
Built on the success of the Cellpro 4s and Cellpro 10s chargers, the Cellpro Multi4 represents the next step forward in charging technology. So much more than just another charger, of course the Multi4 is based on FMA''s time-proven, reliable hardware designs and safety algorithms, but sports a new microcontroller that is 4 times as powerful as the one used in the Cellpro 4s. But the true power of the charger stems from totally new firmware. We started with a clean sheet of paper and a lot of "thinking outside the box". The extensive list of features and capabilities are rivaled only by the goal to provide the ultimate in flexibility and utility. Out of the box, the Multi4 will run circles around the competition in terms of simple, yet powerful set up and operation.
For Battery types: Lithium Polymer/Lithium Ion/Lithium Manganese (1s to 4s balanced and 2s unbalanced), A123 (LiFePO4) (1s to 4s balanced and 1s to 5s unbalanced), NiCd/NiMH (1s to 12s unbalanced), Pb (6v and 12v)
Pack capacity: 5 mAh to 32Ah (charge time limited to max 8 hours)
Input voltage: 10-16VDC, reverse polarity protected
Input current: 1A to 5A, software limited, user adjustable using PC software
Power conversion: DC/DC converter, 125 kHz, 90% efficiency
Nominal Output Voltage: 1.58, 3.65, 4.10, and 4.20 volts per cell (user adjustable using CCS); 19V maximum
Output battery charge current: Adjustable range 5mA to 4A, limited by 5A input current*
Continuous max output power: 58W @ +12VDC input
Voltage calibration: Cell voltage measurements are factory calibrated to a standard traceable to NIST; calibration is to +/- 6 mV
Current calibration: Charge current is factory calibrated on a 4A standard; calibration is to +/- 1mA
Measurement accuracy:
Voltage resolution: 0.1mV
Voltage tolerance: +/- 6mV
Charge current: +/- 1%
Capacity added to pack: +/- 1%
Percent capacity (“Fuel”): +/- 20%
Serial data output: 19.2kbps, 8 bits, 1 start bit, 1 stop bit, no parity
Data integrity: Checksum, CRC checking
Output battery connector: “Cellpro” compatible, JST PA series, 5 position
LCD: 2 line, 16 character, light grey/blue backlit
NOTE: Balancing boards are sold sepperatly. Please see related products.
* Please note, available charger current may be limited for certain battery types depending on the number of cells charging in series and also by the ambient and internal temperature of the charger during operation
| Manual | Download [792] |
Only registered users can upload files.
Please log in or register to start helping your fellow hobbyists today!
