• 现在用OneShot125运费 。
BEC：N / A - OPTO
Best ESC I’ve used.
Works straight out of the packet, no flashing or calibrating wide and smooth range of throttle operation.
Great product HK definitely getting more.Great value and well working 30a esc. I had no issues with this, although I did change the firmware from from SimonK to BLHeli. I found that the esc ran the motors much smoother, but still worked fine on both sets of firmware. The esc is fairly wide, so mounting this was a little difficult on a tight frame, especially compared to some of the new esc's on the market but these work great, especially for a larger copter than can accomodate the size.top produkt easy to program with usb linkeBought 4 of them, using for a multirotor.The have NO HEATSINK on it an should handle 30A, as labeled...NEVER!..sorry the will burn down at the max current in a few minute.First i placed a heatsink on them,much,much better.Second thing, they selled as " with Optocoupler"..also NOT, measured the hole pcb, there is a galvanik contact from the input of the PPM-Signal(orange wire) to the controller ..below 1k..this shouldn't be.If you modify it with heatsink it's useable but i will make long duration test( around 15Min.) at 50pcnt power, if it handles, it's okay.Overall a max. of 3Crowns, cause of the missing Heatsink and no optical input.Worked flawlessly, as to be expected of AFRO ESCs.Also Bisher kann ich keine auffllikeiten feststellen !!!
Sind sehr gut verarbeitet und machen ordentlich druck :-D
Ganz klare Kaufempfehlung !!!These ESC fit perfectly in my Quanum XJ470 folding chassis. I have found they work very well after proper set up. Also note these do not have a built in BEC so you will need a power control board or if using in a fixed wing plane an external BEC. I own 2 quads with Afro ESC and have had no problems with them.Initial impressions of this were good, smaller and lighter than my emax escs and the solder looks top notch. Plugged in, cal'd, and flew, these things don't get anywhere near as warm as my other 25a escs. Maybe because it doesn't have the bec but I am quite pleased. Tested the battery cutoff and it's like they were wirelessly connected because the quad just came down gently.
Note it did not flip and fall and break everything like my other escs would, just sayin.The Best ESC at affordable price.With USB tool for future upgrading firmware.Very Nice ! - flashed with Blheli 14.0 just for the heli of it - enabled oneshot but forgot about setting PWM Damped Light braking. Using on FPVReconn 270mm, 4S, Cobra 2100KV, 6x4.5 - Wow! Impress your friends :>) These ESC's don't even get warm! Also recently purchased the Afro 20 Opto Race...those are great too, and I remembered active breaking - Warpquad is going to be a blast.
Oh..just use the orange signal wire to the naze32 and cut back the black ground - measured 0-ohms from black to black on esc - have not had any signal problems using this method.