四核/六溴/三/双/ Y4 / Y6 /章鱼/摄像机万向节。 （默认是Quad-X）
•多达8通道遥控输入 - 支持标准的接收器（PWM），PPM总和接收机（睿思凯等）的Spektrum或卫星接收机。
•现代的32位处理器在3.3V / 72MHz的（STM32F103CB）上运行。
12x2排针 - 直头选项（打破它分为4个2×3的电机/遥测引脚）OR
3×6直角接头和2x3直角接头 - 直角选项
组态软件 - 铬Baseflight配置（首选）
Great older board, good price.Great fc, used it on my epipdb by quad otters enzo, definitely recommend this board.Great flight controller.
Works just fine, great price and easy to program. Very happy with this FC, no problems so far, I run Cleanflight on it with pwm, but no problems, works as expected!This boards are really great if you are looking for tidy wiring and direct onnections. Be prepared to be able to solder though.Great Flight Controler!
I had a cc3d atom before, i flashed both of them to cleanflight and flew them in the same copter, so i could compare them. At first I noticed, that the naze32 semms to work a lot faster! It connects much faster to my cleanflight software than my cc3d did before. I haven`t flown it for that long, but until know I could really recomend it! There had just been a little issue with setting it up, because my channel 1 was not the channel 1 in cleanflight and so on with the other channels, but I had that issue with my cc3d before too, so Iam not sure if it?s not cleanflight?s fault.
All in all pretty nice product.eine der besten fc am Markt gnstig und gutEpic control board. I previously have had two kk2 boards and haven't been happy with them and had to get refund from hobby king twice and had great customer service. I then bought this board having seen that flite test uses this board. Has great control and better programming than kk2. For me it was very easy to use after watching flite test's setup videos stuff. The auto level isn't yet setup perfectly but the manual mode is good enough and very stable. Well worth buying and a great little fight control board.great FC for acro, you only need to short the boot-pin to flash your favourite firmwareVery good flight controller! I use it for a 210 mini quad, it is much, much better, more precise than the KK2 board, I had before. It is also very cheap for the value. I use it with cleanflight, and I think it is perfect! My only downside is the USB connector is on the back, not on the side, so it's not so easily accessible, but that's all.Love this nice board on my x525 quad... I use it with CleanFlight added a simple NMEA ttl GPS on 57600 and 5Hz for FPV OSD only (not for GPS based flight modes) bought at banggood. This version is simple without Baro or Magnetometer, but for learning and enjoying FPV flying with some soft 3D moves it is a great choise. This board is revision 5, but good as much as version 6... see or feel no difference in flight at all.
CLI Variables download now [63kb] Naze Basic download now [566kb] Naze32 manual download now [341kb] Graupner HoTT Telemetrie 2 download now [359kb] Graupner HoTT Telemetrie 3 download now [2191kb] Graupner HoTT Telemetrie 1 download now [534kb] No File Name download now [590kb] Thanks HK download now [3737kb] Updating download now [724kb] Updating parts download now [12kb] No File Name download now [1366kb]