注册

Product Finder

设置

Useful links

 
[["US","AU","GB","DE"]]
注册

全金属Servoless 100度收回的大型模型(6千克)W /12.7毫米引脚

全金属Servoless 100度收回的大型模型(6千克)W /12.7毫米引脚

Now save 保存 AU$ 0.00 AU$ 0.00

AU$ 37.11
缺货!
Rating:
Stock:
OUT OF STOCK
重量:
200
SKU:
9107000239-0

Price War

产品介绍

全金属Servoless收回对大型号多达6公斤。设计12.7毫米奥莱奥滑柱夹。功能全金属结构精度,可靠性和耐用性。这使得一个优秀的,可靠的替代航空和机械操作收回系统在更大的车型!

眼镜:
工作电压:4.5〜7.4V
安装板尺寸:59毫米点¯x42毫米
螺丝孔距系统:43mm点¯x30.5毫米
运行速度:6V:6秒/ 100度,7.4V:5秒/ 100度
深度:35毫米
长度:86毫米
引脚:12.7毫米
最大模型重量:6kg
重量:140克

Product
Specifications

额外信息

  • 商品编号:
    9107000239-0
  • Brand:
    N/A
  • 重量(g)
    200.00
  • 长度
    95.00
  • 宽:
    55.00
  • 高度:
    90.00
Community
Discussions
Rate&
Review

撰写您自己的评测

Only registered users can write reviews. Please, sign in or sign up

Quality
Value
Overall
Hard to find much fault at the price... but as mentioned in comments above they are not 100 degrees only 94 degrees !!! When you power down they (obviously) stay in position, either up or down. Really nice failsafe however - that if you power-up again in "gear-up" mode when the gear is down (or vice-versa), then they do not respond until you cycle the command - so your pride & joy doesn't fall off its perch if you power up with the gear switch up! (You haven't done it?)
Quality
Value
Overall
Quality
Value
Overall
Listed dimensions are mostly accurate. Top plate is 59mm x 42mm, 35mm tall overall. Base is 27.5mm wide and 89mm long, including the motor. Retracts do not change position at power up, regardless of switch position, so your plane won't drop to the round when you switch on your receiver. Each unit weighs 142g.

Very strong. Tested with a 2S life powering the receiver... I have not been able to trip the overload protection by hand ... I'd probably have to jam them with a screwdriver!

Bought one of these and a pair of the 100-degree units. I' hoping they'll fit my ESM DO-335...
Quality
Value
Overall
Upload
Videos
Upload
Files

Only registered users can upload files. Please log in or register to start helping your fellow hobbyists today!

产品标签

使用空格分隔标签。使用单引号(')标注词组。