注册

Product Finder

设置

Useful links

Live Chat
 
[["US","AU","GB","DE"]]
注册

阵风双床EDF喷气EPO

阵风双床EDF喷气EPO

Discontinued Product

Please continue searching for a similar product.
Rating:
Stock:
OUT OF STOCK
重量:
4470
SKU:
LP01/02/LE
产品介绍
阵风双床EDF喷气EPO
翼展:830毫米
长度:1100毫米
身高:385毫米
飞行重量:1400G起来
伺服:9gx5pcs或8件
动力系统:LEDT-68-1AP39x2
推力:可达1350克
功能:收回起落架系统,全尺寸功能前翼的性能
ECS:40A以上×2
收音机:6CH
电池:锂聚合物11.1V 2200mAh的3S×2
必需的 ;
2xESC
49克舵机
2x2200mah 3S脂
TX和RX
Product
Specifications

额外信息

  • 商品编号:
    LP01/02/LE
  • Brand:
    N/A
  • 容量(mAh)
  • 重量(g)
    4470.00
  • 长度:
    0.00
  • 宽:
    0.00
  • 高度
    0.00
Community
Discussions
Rate&
Review

撰写您自己的评测

Only registered users can write reviews. Please, sign in or sign up

verified_user Quality
trending_up Value
playlist_add_check Overall
one motor is big and one is litel smoel

Retract lanthing gear system does not fit in good the canards are not un the same hight one is up........

verified_user Quality
trending_up Value
playlist_add_check Overall
verified_user Quality
trending_up Value
playlist_add_check Overall
very nice and very nice looking on air went flying
verified_user Quality
trending_up Value
playlist_add_check Overall
verified_user Quality
trending_up Value
playlist_add_check Overall
as I can buy and download this model to Brazil, informed step by step the import procedure
verified_user Quality
trending_up Value
playlist_add_check Overall
verified_user Quality
trending_up Value
playlist_add_check Overall
Great looking EDF jet.

The twin fans are pre run and balanced at the factory. If you look under the cardboard support you can see a little sticker with the test data.

The retracts are the only thing that appears to be sub par. Getting the linkage to work smoothly without binding is a chore. I'm using a 8ch receiver with 3 of the channels for the gear retracts so I can set the travel in my radio.

HTX900 servos fit perfectly into the servo slots.

you'll need a servo Y harness for the esc's, and 2 short, 2 med, and 2 long extensions.

The control surfaces come prehinged and on mine are very stiff. They will need to be redone. Minor foam cutting was needed to fit the esc's. Sanding and cutting was needed to fit the landing gear. The hex rod that supports and turns the canards was binding very badly. The glued in support mounts needed to be broken out. Foam cut to fit them better and put back it. now it works smoothly. Packaging is very good, it arrived in perfect condition. Some minor extra work may be needed but don't let that stop you. This is a very nice Jet.
verified_user Quality
trending_up Value
playlist_add_check Overall
Upload
Videos
Upload
Files

Only registered users can upload files. Please log in or register to start helping your fellow hobbyists today!

产品标签

使用空格分隔标签。使用单引号(')标注词组。