genial para elevar cuerpo y no romper prop al aterrizarWell made and fit well on a Q450 frame. Would be good if there could be an additional strengthening bar available as they make the drone "wobble" a bit on low power take offs, but that's really not something I notice often and it doesn't affect the flight at all.Not totally happy with this, I used it with the dead cat and when I fired her up the drone would fall over.Excellent landing skid with enough clearance for my camera and FPV gear. It attached perfectly to my F450 frameEasy to set up and relatively strong. Very helpful if you are carrying a lot of gear.simple to install and remove and gives you enough extra height to put the underside of the SK450 to use.This is a great set of landing gear for the SK450, and/or the SK450 Deadcat. Defiantly a must for adding a gimbal or FPV fear. I was surprised to find out its actually a great set of landing gear.These landing skids fot perfectly on a DJI F450. You can install them in two different ways (pointing inwards, like on the picture) or pointing outwards. Both ways can be done without drilling ! Just fix the skids around the existing short landing legs of your F450.
With these skids, the F450 has sufficient ground clearance to carry even somewhat larger gimbals !Very nice quality, well cut and came exactly as advertised. I run them on my Deadcat conversion. I recommend instead of directly screwing them onto the frame like you're supposed to but to attach them to the frame with zip ties so they break away if you have a bad landing.Sehr gute Qualitaet und Verarbeitung. Ich montierte dieses Landegestell an einen TBS-Discovery.