这个多功能FPV无人机PDB为了您Naze32 / F3飞行控制器已经被设计成具有赛车的性能和可靠性。启用明快，扎实的供电到您选择ESC年代，也是进出照相机供电，发射器的LED等。
•配电板+ 5V / 12V BEC + OSD
•双BEC，5V / 12V
输入电压：5-24V DC（2-6S LiPoly）
BEC：5V / 2A＆12V / 2A切换
I recently purchased this board and the I must say the wire layout is nuts!!! Should have been 6 pads or 12 pads labeled /- beside each other , not 1pad for 3wire all( ) VCC and another pad for (-)GND then switch them on the other side of the board to GND and VCC. Next no easy way to access OSD menu or even away to tell you how to connect with FC. Next a manual would be nice as to tell you not to hook up wires to the VCC/GND on the Vout ports if your using a vtx that has it's own power cable and feeds the camera power also.
I got the set to work without plugging in the power lead for the vtx I let the V/out port power the vtx. Strange thing when I plug battery pack in to PDB board Vtx power all the way on. If anyone is using a V2 cricket from Rmrc don't plug the vtx in to the PDB board while using all the V/out ports as both V/in and V/out provide power. I think I need to plug the power lead wires into the V/out port so It can power the vtx and I get to turn it on and off when I choose. As of now when I power the board the v2 cricket turn all the way on (green light) and that's not suppose to happen. I will attempt this soon and hopefully figure out how to get the both boards talking to each other as far as battV / timer / and flight mode. I will post again soon once I work the kinks out!!