专为只架，H-KING ESC是需要一个50A ESC线性的，尖锐的，可靠的油门响应任何平面的最佳选择。
Bought 2 of these. XT60 and 3mm motor connectors already neatly fitted.
Receiver lead a bit short, otherwise an
excellent product.Für den preis super, einfach über die fernsteuerung zu programmierenHave had two of these installed in one of my FPV planes. Bought them for the light weight and convenience of pre-installed connectors. Both have failed in the air. Luckily using a separate BEC and was able to keep control of the aircraft to land. Running 4s setup 42 amp max draw. Had good cooling airflow but they seem to run very hot and would quit working completely after a few minutes of hard running. Once cooled off will work again (for short periods) Might work better with a lower amp draw...ESC is very good, not hot.This esc I have not a single complaint with, and I have purchased many of them. Not one have given me even a single problem, and work v3ry well on my fixed wing aircraft.Brilliant. Simple to install, easy to set up and comes with 3.5mm bullet connectors and an XT60 plug already attached. I've been using the 35A version for a while in my scratchbuilds so it was an obvious choice when I needed a larger ESC.
I fitted one to my Hobbyking T45 Goshawk in place of the supplied 30A ESC and it delivers excellent performance.This esc can handle pretty good but can use a better wire thickness wires get hotAs long as your power requirements for servos are low - moderate as the BEC is Linear 2A only ... these ESC are fine. Do not exceed 45 - 50A at all though ... burst current is not advised and will shorten its life - possibly fail. My recc'd is to keep this ESC for 35A max use ...
Interesting is that - the shape and size is perfect fit into recess in JPowers (Mini 50mm) T45 ESC slot. It is a good upgrade for that model and allows a 4S pack to be used.
My twin Floaterjet powered Tu144 on Wattflyer.com is controlled with a pair of these ... very good.
Well - I use these on many models ... and they are good value. Because they are LINEAR BEC - you do not need to disconnect one red lead BEC on multi ESC installations. You can plug in all ESC's without worry and all BEC's will be fine. This also increases the amps available in multi's for servos.Simple to use and program