RPM / V：830
空载电流：1.1A / 10V
Unit Weight (g):
Exellent motor, 150 grams with mount and prop adaptor, comes with 3.5mm bullets already fitted.
Peaks 700 amps on 4s and 13 6 apc type prop, peaking at 50 amps, sustains 560 watts and 40 amps after 15 seconds full throttle. Motor not even warm at that. Great for any 1100 to 1400 gram 3d bird.The Quality of the assembly good.
And even balanced.
4 stars for minus 30kv only, the general turn 800kv.14.03.2011
This is a very good motor for planes up to 5 lbs.
Here some results tested with my watts up:
Zippy 3S 2200 20C, (old lipo - 11,8V), -APC 14x7E, 29,9A, 303W
Zippy 4S 2800 30C (new lipo - 16,6V), -APC 12x8E, 46,3A, 692W
Zippy 4S 2800 30C (new lipo - 16,4V), -APC 11x8,5E, 36,6A, 556W
Zippy 4S 2800 30C (new lipo - 16,2V), -APC 13x6,5E, 49,8A, 727W
I use it in my ASW 28 - 2,7m, 1,8 kgUsed with a Master Airscrew propeller 12x8 on a Multiplex FunCub. It draws around 41 amps. The motor has great power!!!Nutze den Motor in Multplex Funcub mit 13x4 und Mystery 40A Regler.
Macht einen soliden hochwertigen Eindruck.Got the motor this week and have it mounted on a very non-aerodynamic plane. Using a 11x5.5E APC prop and a 4S 4000mah pack. The planes flies very well. The motor is quiet and performs without any issues. I have not seen any overheating with the motor pulling about 500w at full throtle. From my bench tests, it appears that the motor can handle more power but I have limited it to 600w based on the size and winding wire used. I don't know if it can make the 1KW as stated and I'm not willing to trash a motor to find out. I plan on getting more of these as they seem perfect for a 4S setup and planes about 4-5 lbs. in weight.