最大电压：7.4〜11.1V（2S / 3S）
Ottimo prodotto dal prezzo contenuto. Montato con esc HK sulla mia tt01e e gi di drift, spettacolarefitted the 10.5 to my Tamiya M04EL (long wheel base 190mm width modified M-04) car with an X car 60a esc , superb combo , had to reduce the boost , timing and punch as it was a handful , i did find the large gap between the sensor input and motor wiring tabs to be a bit poor but covered it with a bit of blue tack as any dirt/moisture that makes its way into the sensor board could cause it to malfunction , even a bit of tape over the large gap will help , other than that one small omission its a great value ,very quick motor that only gets luke warm with the car running its largest gear at about 5:1 final reduction .Excellent motor. Retrofited it on one of our Amewi Short Course.
In Combination with HK 80A ESC using the sensor option perfect throttle response, low heat.
Came with sensor wire. I wasn't too sure on how to solder the wires on, I had to put them on top of the tabs due to motor location. Cups would be, and are much better. It ran fine, as expected from a sensored motor with the esc having a low punch setting. Seems you can change the timing by removing the three screws and turning the front end as there are extra screw holes on the back. I've currently left it as standard, in the center. It's not fine adjustment, just one forward, one back.WORK VERY WELL ON MY DRIFT KIT ( TEH-R31 FO ), PINION 20T AND SPUR GEAR 87T, CS : 1:1,9, TEMPERATURE MOTOR AND ESC 40 C DEGREE , USING ESC HOBBYKING SENS 60A. SILENT AND SMOOTH. VERY RECOMMENDED.Ok i pay with pay pal wate three weeks and go on this site and see that it says NO PAYMENT??? Pay pal and my bank have taken money out of Hobby King was payed out of my acount,, and the email i sent Hobby King to find out what is going on said it was full and not sent back to me? What do i do now? I sent money for three batterys as well, Am i out $120 Bucks or what?I am using this motor in my Associated SC10 2wd and it works great. It definitely has enough torque and speed for this kind of car. I use a motor pinion with 24 teeth on it. The motor temperature also behaves very normal, about 40-60. I am driving on an outdoor clay track with a lot of jumps in south-germany, outdoor temperature was always about 25.Un buon motore x una car 1/10, usato con esc Scanner funziona alla grande e senza impuntamenti. Ha una buona coppia e un discreto allungo, che forse si pu migliorare regolando l'anticipo, cosa che non ho fatto, perch quello disponibile mi gi troppo, per fare drift non serve chiss che potenza, ma con questo motore ho un notevole aumento di durata delle batterie rispetto al brusshed originale. Un buon acquisto e se torna disponibile n prender un altro per la seconda car!!crazy motor car for drifting.Put this in my TT-01 and felt it was about the right size for my kind of driving. For standard scale power sliding I turn the throttle down to 60pcnt and still have plenty speed. At 100pcnt my car was gonna take off unless it had a very smooth speedway. Looks great too.