如果你正在寻找完美的公园飞行模式或只是一个轻松的周日传单，看看这个！迷你微风是一个漂亮的“豆荚和繁荣”的风格滑翔机，这只是顾名思义 - 一个真正的“微风”飞行。它不仅是容易上手，很容易打造为好。 Mini的微风可以随时在飞行约15分钟！
这种迷你微风的版本出现急性肾功能衰竭（几乎箭在弦上）与1306 3100KV无刷电机包括在内。您只需要添加自己的3.7克舵机×4，6A无刷电调，4通道无线电系统和2S lipoly电池来完成这个模型。
•几乎箭在弦上W /电机 - 只需添加你自己的无线电系统，伺服系统，ESC和电池
I bought a second mini breeze glider after the first one crashed beyond repair (not the plane's fault) - it's a fun plane to fly - I'm an experienced modeler but a beginner RC pilot - the model behaves well. I bought the recommended components except the battery which was a little too big for the space available (shipping of lithium batteries by air is not possible). The only issues I had was that the aileron servo leads are too short and I had to splice extra wire to make them work - I tried 30 cm extensions (F26S) but there was not enough room in the fuselage for the extra wire - 10 or 15 cm extensions are sufficient. I ended up making the Y leads a custom length. The other issue was figuring out how to position the receiver and rudder and elevator servos so that everything fit. The solution was to place the ESC on the side wall of the fuselage beside the elevator and rudder servos, and put my too-big-for-the-space battery on a platform I made with carpet tape that spanned the opening. It worked fine and I trimmed it so that the tape was invisible. Flying it at half throttle max worked well for learning how to control the model. I also purchased the HK RC flight simulator and this helped a lot - but don't fly for real until the controls are second nature is my best advice.Nice little glider. It does have a problem with the wing joining system though. It's only a small joiner (not like the full length spar that the floater jet has for example) and it tends to break quite easily. The two wing halves are only connected via that one joiner which is near the front of the wing so it isn't very stable.
The elevator is also a little stiff and the side with the horn tends to move more than the other side. I cut the hinge line and used blenderm tape and also put a small carbon fibre rod along the elevator.
Otherwise, not bad. I think the floater jet might be better though