What a great plane. Handy size, easy to finish. And best of all: flies fantasticly out of the box. Really. Never had a 3D plane that flew better. The Bravado is fantastic, but not for easy 3D, the MPX Acromaster needs too much care as does my 48" Yak. This Edge does what she is supposed to be out of the box. And even the CG is correct without any corrections. My best 3D buy so far.Great little 3D parkflyer. Very responsive and tracks well at higher speeds. But is stable and doesn't have bad habits when flying slow and low. Wing loading feels fine to me even using heavier 17g servos. I tried the recommended size motor on 3s with a 10x5 prop and it was way underpowered for 3D. Ended up using a Scorpion 2215 900kv with 4S 1000mah lipo and 10x5 prop. This setup has plenty of punch. Still working on best CoG point, the CoG marked on the wings is a good start but for 3D most will find it needs to go back. Overall an awesome plane. My airframe was nicely assembled, everything fit together well, tail surfaces aligned and needed no shimming. Kit hardware is just OK, but usable (I'm probably going to upgrade to ball links).I love this plane. Make sure you re enforce the motor mount and battery tray.
I used 30 minute Z-Poxy and its holding up verry well. Don't know why everyone is so scared of battery weight. I fly it with a Thunder Power 2700mah 25C 3 Cell for light 3D and longer flight times
and it is just fine after 70 Flights on that battery. I also have flown it with an 1800 45C 3Cell doing faster 3D stuff for about 70 Flights. Here is 2 Videos i did in verry high wind 15 to 20mph. Hope you enjoy all my videos. I will be doing more of this plane soon