该Turnigy多星精英Outrunners是设计时考虑的一件事 - 最大限度地提高飞行器的性能！新的多星精英电机在多转子性能的新标准。每个优秀马达，是为一个特定类型/应用允许进一步完善和效率/功率进行优化。
精英2204〜2300kv是专为多转子的迷你范围和一个5英寸道具优化的电机，适合那些更严格的框架，其中5寸的道具是最大的一个精密小宝石。 2204有一个可拆卸/可更换滚花道具对于那些偶尔死机轴，哈哈。而在与之相配的硬件子弹CW / CCW味道可用。下运动框架倒角，便于装修更紧帧，并有足够的高度安装硬件缠绕间隙。
KV（RPM / V）：2300KV
空载电流： 0.6A / 10V
螺栓孔间距：16 * 19 M3
11.1V 5X3 50％224克3.7A，
11.1V 5X3 100％371克7.5A
11.1 5x3x3 50％232克4.7A
11.1 5x3x3 100％392克9.9A
7.4 5x3x3 50％134克2.7A
7.4 5x3x3 100％211克6.7A
11.1 6X4 50％385克7.5A
11.1 6X4 100％591克9.9A
7.4 6X4 50％134克4.8A
7.4 6X4 100％211克9.7A
Unit Weight (g):
Motores excepcionais para mini-quad. Acompanhados com o ESC Afro 12A v3 rocam nas horas, e não aquecem muito.
É pena que a indicação CCW e CW digam respeito ao spinner e não à rotação do motor. Para ultrapassar este problema troquei os spinners nos motores e agora está correcto.The Motors are well built, if you have luck.
I purchased 4 and two had a darker color and had quite strong vibrations. The other two were perfectly smooth and run very cool.
The Windings are very good, but the bearing seem to fail after a pretty short time.
After around 30 Flights they are already making typical noises of bearing failure and i am sure the won't last long.Very good powerful motors. You can buy 4 of these then replace the prop adaptors but the CCW prop adaptors don't fit top ell on the motor but the FPV quad still is flying perfectly with no problems. I used 12 12amp ESC's and a 3s 2200mah zippy battery. My flight time is a good 6 minutes in which I was using all the functions on my RC transmitter. The speed of these motors are very fast and even on a self-level mode you still go very far.Been using these for about 6 months, they handle 5045 triblades bullnose on 4S like a charm. I feel like the bearings had wear a little, but I think is normal after so many dozens of packs flown.Not a bad motor for this price, seems to get hot fairly easily.1 out of 4 already dead (burned) after 15 hours flight time. Used on a 3s setup with 5030 propellers. When they run they are really good and very efficient but unfortunately they don't last very long. So my advice: Don't buy them.I ran my quadcopter straight into the street at about a 45 degree angle and the motor still works! It must have been going around 70mph on impact.These Multistar Elite 2204 motors are quite good. Ive had them for over a year now, and am very pleased. Right out of the package the motor bell was well balanced, and no addition of tape would reduce the already minimal vibrations the motors had. They have experienced a little wetness and a lot of hard crashes, theyve outlived 2 frames and are on their third, albeit not CF frames, and are still running well. The bearings are not showing signs of rust yet, and have only now begun to sound like they may have dirt in them or be failing, but the bell is not loose. I would estimate they have over 20 hours of actual run time on them.
I fly a 250 size quad on 3s For the first few months it was 5030 and 5040 gemfan props, then I moved to 6030 gemfan props(larger frame). Both run well with a 12A ESC, and nothing would get too hot after hard flights, just some warmth in the ESCs. The prop/power data displayed on the HK website seems pretty accurate from my experiments. I recommend these motors, however you should buy the ones with the different CW & CCW prop adapters if you prefer using the prop spinners. I used M5 lock nuts for holding the props on after crashing twice from self-loosening nuts on the CW motors.
These are great motors but I do not recommend their spinners. They fall off really easily. I bought nylon nuts (locking nuts) to use instead. The motors are outstanding though.Tough motor. Make sure if you are using this on a plane you utilize some loctite to keep the spinner from getting lost.