Would use them to cover & protect the servos under the wings DG600 but tey are a litllebit too big. I'll use them to modify some covers.These are very large compared to your standard light duty servo. Suitable for larger servosGreat Mount, hard staff!!!These are the best way to mount servos in the wings of models - these take standard type servos (I used futaba 3003's) and fit nice and neatly in the wing for easy installation and maintenance and positive control - highly recommend.zeer goede afwerking en passen zonder probleem op een cularis mpxThe distance from Servo to the extension where the arm is located is way too short. Even a standard servo doesn't fit since the distance from flange to servo arm underside is way too close to the servo arm cover. I tried 4 different standard servo and non fits. That's frustrating since the over all quality is not that bad. A little flexible but good for most apps.
Make sure you tape the servo with double sided glue tape to the bottom of the servo slot.
For use with full sized servos. The protection bit at the top is also very tall, not the most aestheticly pleasing cover but if you have long control horns would work greatWenn sie berlackiert sind, siht man die Servos kaum nochfit well with mini servo, will use it on the flaps on my falcon 120 with mg16 hk servos and on elevator with corona servos.
It's better to glue servo to make covers solid
Might seem a little flexible but use double sided tape when fitting the servo and they become quite rigid. Have yet to find a way of getting paint to stick for long.