该SkyZone TS5823发射机包超净5.8GHz的功耗为200mW的在微尺寸的视频/音频发射器！ A必须为那些希望节省体积和重量，同时仍然获得良好的性能。该TS5823正在传输的全系列32个通道，只重10克。这是完美的一个大范围的飞机，尤其是小型号和大小350多转子，如Quanum新星，DJI幻影，QR X350和更多！
•微米尺寸，重量轻 - 完美的小车型使用
视频格式：NTSC / PAL
TS5823 5.GHz 200mW的32CH A / V发送器
GoPro的USB到A / V电缆（使用GoPro的为A / V输入）
Here it is, a 200 mw vtx for your Jumper. works GREAT, increased range is fantastic.Worked for about an hour then the input power transistor burned up. I had it connected to a 3S Lipo so voltage was well within spec range. Upon further investigation I'm finding many others having the same exact problem: the power transistor burns up. This looks like a defective design.This works perfectly and I am getting much better range than I expected. Super easy to hook up.I plugged it for 30 seconds and it was woking good, but the next day it does not worked, it is not burned, it just do not turn on when i plug the battery, it does not do anything,the smallest transimetter for your quad with a good range of video outterrible range. went from a 1000mw boscam getting further than my FR SKy readio would reache, to this for a smaller quad tried many different channels still 100 yards is all I feel safe with. same antennas as were on my boscam rig so only change was this.I have the Quanum goggle set which I first used with the FPV Vapor indoor airplane with the 25mw VTX. Quite an experience flying in a big dome. Some interference for the low power in this high electronics background noise. Then I put this 200mw VTX on a Stratos and flew outdoors at the club field. What a great view. 99pcnt noise free. I am using the twisty antenna.
Works with a 2s battery.
There is one problem, As reported by others, the cable plugs into a receptacle that is not secured to the printed circuit board as strong as it should be. Add thin CA or some adhesive to keep it from breaking loose. If it breaks free it ruins the anchoring lands it is soldered to.
It is kind of simple but I did realize that the JST connector didn't have a red cable for power, positive and negative were both black so I was confused about soldering. Otherwise its pretty good for its priceAs others have mentioned, my TX burned after five minutes running on the bench!
It is noticed that the regulator burned.
I would not recommend to anyone!
HK what I DO????La prise usb n'est pas standard.
The USB plug is unique and does not fit anywhere.
Did not try the Tx yet