Turnigy 2815 EDF先驱者3500kv 55 /64毫米眼镜：KV-3500尺寸： 为50 x28毫米轴：2.3 /3.0毫米电压：11.1V重量：74克空载电流：1.9A空载转速：38460负载电流：17.8A负载转速：32780推力：485克安装孔螺栓圈：18毫米
Unit Weight (g):
I have a put a post in the forum with stats for this motor a few of its brothers and sisters but ill put them here too. Motor is good quality and I think will run on 4S fine if kept under 500W.
3S 64mm 5 Blade Fan 19A, 220W, 11.7v 450g thrust (in plane)
4S 64mm 5 Blade Fan 30A, 450W, 11.7v 640g thrust (in plane)
3S 64mm 6 Blade Fan 19A, 216W, 11.45v 480g thrust (in plane)
4S 64mm 6 Blade Fan 29.5A, 430W, 14.8v 640g thrust (in plane)I bought 2 of these for a GWS-262. I use 2 25A tower pro ESCs and a turnigy 2200mah lipo. Its too much for the lipo, it gets hot and puffed out. I'll try a 2600 mah next. Great motors, lots of power. Great value.Looks are good, some flaws.
I had to rebalance both of my motors, I needed lots of CA to balance them but after balancing they ran fine.
Axles supplied with motors were 2.3mm , 3mm and 3.3mm , but 3.3 mm will not fit because the hole is already almost too tight for 3mm axle!
I had to use brute force and hammer to get 3mm axle of and install 2.3mm.
Real life performance will tell more.Motor appears to be of good quality. On a GWS 64mm, 6-blade fan, Hyperion 3S 2500mAh 25C, Phoenix 25A ESC-low timing, I was pulling 22 amps and 239 watts at 11 volts WOT. Sorry no thrust data, but holding the unit in my hand produced impressive thrust for a 64mm fan. The website says 17.8 amps as 'load current'. If I understand that to mean max continuous, than a five blade fan may be better. No thrust data, but impressive for 64mm unit.Awesome motor, 540W on peak with a 5*5 prop and a 3S 1600 35C hyperion.