打开大门，可定制的固件所有多星ESC的功能，一个的ATmega MCU - V2的多星配备了预安装BLheli软件，并为那些因此倾向于一个易于使用的USB工具可通过BLHeli套房GUI配置和更新。
BEC输出：5V / 2A
A fine ESC. Doesn't get too hot and provides me enough power.Very light, very small, but its not 10A.
Gets pretty hot even under 5-7 amps in hover mode while cooled by props air flow.
I used them in my Trifecta, they power 1806 motors.Love these esc. I kept going back to my loved afro esc but for the spidex a throw away quad this inexpensive but we'll performing esc is doing the trick.Great ESC for the price. the V2s are a MUST have for a budget multirotor.
I've paired these with the DYS BE1806s and they work quite well once programmed. However, it is important to note that when using the USB programmer you must remove the power lead from the USB programmer to this specific ESC as these ESCs have their own power UBEC.
Additionally, it should be noted that when upgrading the UBEC firmware, you must disable demagnetic compensation completely to ensure you don't burn up your high KV motors. (This features is only available for v13 of the firmware for these ESCS)
So far these have provided cool, steady power to my DYS BE1806s, and calibration was as easy as pie.
My only problem is one of these ESCs (of 6) came faulty and fried the windings on two of my motors. However HK was quick to replace them without issue.Pretty good ESC's. I noticed people are burning these things out a lot. You can't use a high KV motor. Max I would run is the 1900KV on a 250 quad. A 2150kv baby beast would surely burn it out. It works well if you're only planning to use it for a light weight low powered quad with a 5" prop. A 6" prop would blow this ESC. Know the limits and you'll be happy. They are oddly shaped which makes me a bit awkward to mount, aside from that, no complaints. Great price for a decent entry level ESC. Needs calibration out of the box.Small, silicon cable, work great with my motors.No problems running these ESC with DYS 1806 2300kv motors. It's just a shame that the on-board capacitor makes these ESC a little thinker than usual. If you are looking to re-solder the wires onto the ESC, you need to be quite careful, the solder pads for the motors wires are not on the edge of the board, but in the middle (HW Skywalker style!)The Bad:
1) One of 4 came dead. It was replaced by warranty, but god knows when it will arrive.
2) Cucumbercome hardware assembly.
2) Starting with BLHeli (and BLHeliSuite) 12.2 this ESC is officially supported.
One of working 3 was with different settings. So it has sense to check settings before use. Also keep in mind that you can only program it with BLHeliSuite or in programming mode with remote(not very handy). Also I was foolish to order only 4. You probably will need spare one anyway.I haven't had these long enough to see what their longevity is, but on my recent Ghost FPV250 build, they work perfectly. They don't even get warm using the DYS BE18906-2300kv motors. Because of the clear frame of the Ghost FPV250, I removed the phlegm green shrink wrap, and replaced it with clear. Looks much nicer.Have had some go great and some burnt using a 2300kv quad motor. I would say for the money they are ok.