Unit Weight (g):
not direct fits for 1/16. mounting holes will not lign up with your 1/16 models.bought 3 of them. 2 for kyosho blizzard (it has very momentary transmission) so it is ok.
but x-ray m18t pro with this motor and big wheels and 15t pinion starts with difficulties though another motor ~18t starts ok. so it is sad for me. I suppose that this motor has ~10 turns and cannot be used in 1/18 truggy and monsters.MOTOR NOT USABLE OUT OF THE BOX. Exactly as Whipper snapper, bought two of these motors and they both aren't spinning free because the rotor is too tight between the bearings. I tried to open it to try and solve this problem myself but the two phillips screws are impossible to unscrew, I am worried I'll strip the head and end up doing a butcher job just to make the motor usable. I'll come back for an update when I get the time.I bought the motor and found that the rotor is rotating too tough. The size of rotor is large so bearins are blocked. Bad quality. Motor heats up very quickly. Working only on 2S to get full power. 3S block my ESP at full power.Brought 2 of these used one for replacement motor on my Centurion Mini catamaran old one being a 3000kv finally died after 2 years of hard runs...this was a great replacement feels a bit faster but glad made the purchase not over-heating problems def recommend it for the Centurion...i running 35amp esc with 25c 2200mh 3S pack