The camera uses a quality glass lensed SONY CCD system.
1 x SONY CCD 1/3inch Camera
1 x Wiring Loom1 x Lens cap
Camera spec.Image device: 1/3-inch Sony super HAD color CCD
Pixel: 752 x 582(PAL)
Synchronization: Internal synchronization
Horizontal resolution: 520TV Lines
Minimum Illumination: 0.1Lux/F1.2
S/N Ratio: Greater than 48dB(AGC OFF/B/W OFF)
White balance: Auto Tracking White Balance
Auto backlight compensation: On/OFF switchableLens: 3.6-6mm
Input voltage: DC12V
Electric current: 80MA±5MA
Electronic Shutter: Auto
PAL: 1/50 to 1/100,000 seconds
Video output: 1.0Vp~p75Ω
Operation Temp.: -10~+50?
Size: 38 x 38
Power supply: 12V/150mA
Kapacita ( mAh )
Hmotnost ( g )
I didn't get mine to work at first. After spending som time on google I realized that the connector on the PCB was rotated 180 degrees thus switching the signal wire with the VCC wire. A forum friend that just received his camera had exactly the same problem.
After this fix the camera works. I have not yet tested it in a relevant environment so I cannot comment on the actual quality.quality is nice, i've order wider lens to try too. overall great for it's priceFirst the good points - It produces a good sharp image and can handle difficult lighting reasonably well for a camera that isn't user programmable. Now the bad points - The 3 pin plug had the wires reversed - as usual. Why can't they get this right. The stock lens is very ordinary quality and has a narrow field of view. Only suitable for FPV if it is on a pan/tilt. When I removed the stock 3.6mm lens to install a 2.8mm one, I found the sensor cover glass to be badly scratched. So much for quality control.Ahhhh really good... Stop to use garbage board camera, see the differencesmy camara attached to the kit boscam 200 mw does not work. does not transmit any images https://www.youtube.com/watch?v=uOjSBTN4uLklovely crisp picture from this camera. would be better with wider angle of view for fpv, but a suitable lens can be bought from Hobby King to do the job. At first the picture was only black and white and very grainy, this turned to be a dip switch on the 5.8Ghz transmitter not making contact so it was a fuzzy signal, not the camera. similar will occur if the 5.8 tx voltage is lowSo... for the price, I didn't know really if this camera was well or not. I can tell you, this camera is really good. It never remplace a GoPro, of course, but for normal FPV, the quality image it totally enought. I use it with a RC305 and 200mw boscam transmetter. If you want a cheap FPV system, buy this combo and you will be very satisfied.Below are the products you purchased in the last 45 days.
Help your fellow hobbyists and earn free points
Great value for this price.Fairly decent camera. Doesnt like low light and the lens is not good for fpv. At this price beggers can be choosers